urmet LBT 7123 Power Supplies Installation Guide
- June 10, 2024
- urmet
Table of Contents
urmet LBT 7123 Power Supplies Installation Guide
WARNINGS FOR INSTALLERS
Read the notes in this manual carefully. This manual contains important information on safe installation, use and maintenance.
- This device is intended for use as specifically designed, i.e. to power door phone, video door phone and video surveillance systems.
- This device was designed to be compliant with the standards in force. All other use is improper use. The manufacturer cannot be held responsible for damage deriving from improper, incorrect or unreasonable use.
- The system must be built in compliance with the regulations in force. All devices in the system must be exclusively used for the purpose for which they were designed.
- Check that the device is intact after removing it from the packaging.
- Keep the packaging (plastic bags, polystyrene, etc.) away from children. Packaging is potentially dangerous.
- Provide a suitable circuit breaker with a contact opening of at least 3mm upstream of the device.
- Make sure that the plate data corresponds to the power specifications before connecting the device to the mains.
- Keep the ventilation or cooling openings and slots free.
- Disconnect the device from the mains before cleaning or maintenance. Do not use spray products to clean the device.
- Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the device. Do not tamper with the device.
- Exclusively contact a service centre authorised by the manufacturer for repairs.
- Do not install the device in environments exposed to dripping or splashing. Use specific boxes if required.
- Provide suitable ventilation.
- Do not use power extension wires.
- Have the device checked and repaired by qualified personnel in the case of infiltration of fluid or objects inside the device.
- Exclusively use the spare parts supplied by the manufacturer for repairs.
- Installers must make sure that user’s information is applied to the connected devices.
- Disrespect of these precautions can effect safety of the device.
- Keep this manual with the device at all times.
• The lightening symbol in a equilateral triangle indicates the presence of dangerous voltage. Do not open the device.
• The exclamation mark symbol in an equilateral triangle indicates critical safety components. Always only use components supplied by the manufacturer.
IMPORTANT : Apply the device as shown below for installation on the wall, where applicable, to avoid injury (pag. 4).
DS 110-001L
URMET S.p.A.
10154 TORINO (ITALY)
VIA BOLOGNA 188/C
Telef. +39 011.24.00.000 (RIC. AUT.)
Fax +39 011.24.00.300 – 323
LBT 7123
Area tecnica
servizio clienti +39 011.23.39.810
http://www.urmet.com
e-mail: info@urmet.com