saunalife E7W Barrel Sauna Half Glass Window Instructions
- June 16, 2024
- saunalife
Table of Contents
saunalife E7W Barrel Sauna Half Glass Window
Product Information
Specifications
- Product Name: Ergo-Series E7W Barrel Sauna Half Glass Window 71D x 81H
- Model: E7W
- Dimensions: 71 inches in diameter, 81 inches in height
- Material: Wood
- Weight: ~2lbs
Product Usage Instructions
Tools Needed
- Measuring tape
- Marker pen
- Circular saw
- Water level
- Hammer
- Ratchet strap
- Extra hands
- Silicone gun (Only for glass-wall models)
- Drill
- Crescent wrench
- Utility knife
- Rubber mallet
Wooden Front Wall Installation
Before starting the installation, make sure you have all the required tools and materials.
Step 1: Preparation
Place the details on a flat, level surface. Make sure you have all the necessary components.
Step 2: Fixing Brackets Inside Vent
Fix the brackets inside the vent to make the wall more rigid during the installation.
Step 3: Proceed with Main Installation Manual
Follow the main installation manual for further instructions on completing the installation.
Half-Moon Wall Installation
Before starting the installation, make sure you have all the required tools and materials.
Step 1: Apply Waterproof Silicone
Apply waterproof silicone into the groove of the half-moon wall.
Step 2: Pre-Drill Screw Holes
Pre-drill screw holes on the half-moon wall. Take caution not to let screws touch the glass.
Step 3: Cut and Remove Straps
Cut and remove the straps on the half-moon wall.
Step 4: Apply Waterproof Silicone
Apply waterproof silicone to the half-moon wall.
Step 5: Check the Main Installation Manual
Refer to the main installation manual for additional instructions on completing the installation.
General Installation Guidelines
Before starting the installation, make sure you have all the required tools and materials.
Step 1: Diagonal Measurements
Ensure that the diagonal measurements are equal to 63 inches.
Step 2: Position Cradles Inside Grooves
Position the cradles inside the grooves of the sauna walls.
Step 3: Fix Temporarily to Support Walls
Fix the sauna walls temporarily to support them during installation. Use a water level to ensure accuracy.
Step 4: Leave Space for Adjustment
When tightening screws, leave a 1/4 inch gap to allow for adjustment when installing the outer bands.
Step 5: Use Straps for Board Support
Use straps to support the boards during installation. This will ensure stability and proper alignment.
Step 6: Join Boards Together
Join two boards together to bridge any gaps. It is recommended to have the combined boards 1/4 inch wider than the gap.
Step 7: Fasten the Boards
Fasten the combined boards using screws.
Step 8: Install Outer Bands
Place the bands around the barrel on the outer side of the cradle.
Step 9: Remove Temporary Bracing
Remove all temporary bracing once the installation is complete.
FAQ
Q: What tools do I need for installation?
A: You will need a measuring tape, marker pen, circular saw, water level, hammer, ratchet strap, extra hands, silicone gun (for glass-wall models), drill, crescent wrench, utility knife, and a rubber mallet.
Q: Can I install the sauna without using straps?
A: Using straps during installation is recommended to ensure stability and proper alignment of the boards.
Q: How much space should I leave when tightening screws?
A: Leave a 1/4 inch gap when tightening screws to allow for adjustment when installing the outer bands.
Front & Back Walls
Dimension
Tools needed
Wooden front wall installation
Half-moon wall installation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>