CANARMNA IFM742B13 Dexter Ceiling Light Fixture Instruction Manual

CANARMNA IFM742B13 Dexter Ceiling Light Fixture

Product Information

Easy Connect TM
Easy Connect TM is a lighting fixture that can be easily installed on an electrical box. It comes with mounting bracket, electrical wires, and a shade. The fixture can be connected to live, neutral, and ground wires of the electrical box. The product is available in two variants: IFM742B13 and IFM318A13-EC. The product requires a Phillips screwdriver and wire cutters for installation.

TOOLS AND MATERIALS REQUIRED:

Product Usage Instructions: Easy Connect TM

1. Turn off electrical power before starting installation of the light fixture. Do not remove insulation from the fixture.
2. Install the mounting bracket to the electrical box using two electrical box screws (not included).
3. Connect (push) electrical wires from the fixture into correct inserts. The black wire should be connected to live, white to neutral, and green to ground.
4. Tuck the electrical wires into the electrical box and position the key slots over the support screws. Turn and lock the support screws into the key slots. Tighten the support screws into place.
5. If there are multiple black wires joined in the electrical box, attach a single black and white jumper wire before connecting. Strip 7mm from a 6-inch jumper wire supplied. Then connect (push) wires into correct inserts.
6. Install the proper bulb type and wattage (not included).
7. Push the shade upward and turn as shown. Lock the shade by tightening thumb screw against the fixture on the side.

Note: This product must be installed in accordance with the applicable installation code by a qualified electrician.

SAFETY PRECAUTIONS

1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE. DO NOT REMOVE INSULATION FROM FIXTURE.
2. WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
3. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
4. CAUTION – RISK OF FIRE. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.

NOTE: Product may not look exactly as shown in figures.

INSTALLATION

1. Install the mounting bracket to the electrical box using two electrical box screws (not included).
   ( Note: Do not adjust the two support screws at this time.)

2. Option 1: Connect (push) electrical wires from electric box (house wiring) into correct inserts.
   Option 2: For multiple black (live) & white (neutral) wires joined in the electrical box (house wiring), attach a single “black” and “white” Jumper Wire before connecting. Strip 7mm from a 6” Jumper Wires supplied. Then connect (push) wires into correct inserts.

3. Connect (push) electrical wires from fixture into correct inserts.

4. Tuck the electrical wires into the electrical box and position the “key slots” over the support screws. Turn and lock the support screws into the “key slots”. Tighten the support screws into place.

5. Install the proper bulb type and wattage (not included).

6. Push the shade upward and turn as shown. Lock the shade by tightening thumb screw against the fixture on the side.

Our service team is ready to answer your questions…
1-800-265-1833 (English) / 1-800-567-2513 (French)
Tel: 613-342-5424, Fax: 800-263-4598

IN CANADA – ressalescanada@canarmna.ca

IN USA – ressalesusa@canarmna.ca

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>