MOEN YB6324BL Summit Towel Bar Instruction Manual
- June 10, 2024
- Moen
Table of Contents
MOEN YB6324BL Summit Towel Bar
Product Information
SUMMITTM Towel Bar
The SUMMITTM Towel Bar is a wall-mounted towel bar that comes in two sizes
– 18 inches (45.72 cm) and 24 inches (60.96 cm). It includes mounting posts,
screws, plastic toggle anchors, and a mounting template for easy installation.
The mounting posts feature slotted holes that allow for spacing adjustment
after installing the product.
Product Usage Instructions
- Position the mounting template on the wall in the desired location.
- Using a level, align the template and tape it to the wall.
- Drill two 5/16 holes at each mounting post location that corresponds to your product.
- Remove the template from the wall.
- Fold the ends of the plastic toggle anchor together and insert them into each hole in the wall.
- Lightly tap anchors until flush with the wall.
- One at a time, insert plastic pin into each anchor and lightly tap to activate anchor.
- Remove the pin and repeat on all anchors.
- One at a time, place each mounting post over anchors and insert screws through post into anchors.
- Tighten the screws.
- Place posts over the mounting posts with setscrew facing down and tighten setscrew.
Note: Make sure to adjust the spacing between the mounting posts using slotted holes before tightening the setscrew.
Tools Required
- Phillips screwdriver
- drill
- 5/16″ drill bit
- hammer
- level
- tape
- Post Product Hardware Kit Contents:
- 2 toggle anchors
- 2 wood/anchor screws
- 1 plastic pin
- 1 hex wrench
- Post Product Hardware Kit Contents:
- 4 toggle anchors
- 4 wood/anchor screws
- 1 plastic pin
- 1 hex wrench
Note: Directions below are for installation into drywall. If installing product into a stud, use the wood screws only.
INSTALLATION
- Position the mounting template on the wall in the desired location.
- Using a level, align the template and tape it to the wall.
- Drill two 5/16″ holes at each mounting post location that corresponds to your product.
- Remove the template from the wall.
- Fold ends of the plastic toggle anchor together (see Figure 1) and insert into each hole in the wall.
- Lightly tap anchors until flush with the wall.
- One at a time, insert plastic pin into each anchor and lightly tap to activate anchor (see Figure 2).
- Remove pin and repeat on all anchors.
- One at a time, place each mounting post over anchors and insert screws through post into anchors.
- Tighten the screws.
- Place posts over the mounting posts with setscrew facing down and tighten setscrew.
Note: The mounting posts feature slotted holes which allow for spacing adjustment after installing the product.
Level Line
25300 Al Moen Drive • North Olmsted, OH 44070-8022
Customer Service USA:
1-800-882-0116
International Customer Service:
1-440-962-2263
Summit™ is a registered trademark of
Moen Incorporated ©2021
www.moen.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>