KOZY HEAT SP-34 Direct Vent Fireplace Instructions
- June 10, 2024
- Kozy Heat
Table of Contents
SP‐34 Direct Vent Fireplace
Please leave these reference guides at the installation location until the
installation is finished. See owners manual for full installation and
finishing instructions before making final decisions as information is subject
to change.
Specifications (all measurements are in inches)
Model| BTU| Height| Front Width| Back Width|
Depth| Glass Viewing Area
---|---|---|---|---|---|---
Actual| Framing| Actual| Framing| Actual| Framing| Actual| Framing
SP‐34| 20,500| 30‐7/8| 33‐1/2| 34| 34‐1/2| 27| 34‐1/2| 14| 14‐1/2| 27‐1/4 x
19‐3/4
- GAS LINE OPENING: RIGHT SIDE
- ELECTRICAL ACCESS: LEFT SIDE
Framing Opening
| Dimension | SP‐34 |
|---|---|
| A | 33‐1/2 |
| B | 34‐1/2 |
| C | 14 |
| Dimension | SP‐34 |
|---|---|
| D | 14 |
| E | 34‐1/2 |
| F | 14 |
| G | 34‐1/2 |
| H | 54‐7/16 |
| I | 34‐1/2 |
| J | 13‐1/8 |
| K | 27‐1/4 |
| L | 38‐1/2 |
Finishing Clearances
| Dimension | SP‐34 |
|---|---|
| M | 4‐1/2 |
| N | 12 |
| O | 42 |
Mantel Clearances
MANTEL PROJECTION: 1” UP FOR EVERY 1” DEEPER (After ini al 37”)
Dimension
P| Q| R| S| T| U
37| 6| 1| 33‐1/2| 12| 42
Finish Trim Kit
Important!
If you are finishing around the fireplace with tile or stone make sure that you
install the Optional
Finishing Trim Kit at the framing stage.
The trim kit allows for your finishing board and your le/stone to finish up
against, creating a shadowbox.
Horizontal Termination Framing
| Dimension | SP‐34 |
|---|---|
| V | 14 |
| W | 35‐1/4 |
| X | 14 |
| Y | 42 |
A Kozy Heat #700‐WPT series wall pass thru is required with use of the flex‐vent kit.
Horizontal Venting Minimum Requirements
| Requirement | SP‐34 |
|---|---|
| (NG/LP) Vertical Min | 90o Elbow |
| (NG/LP) Horizontal Min | 6 |
| (NG/LP) Horizontal Max | 4 |
Consult venting chart in manual for op ons above minimum requirements
| Requirement | SP‐34 |
|---|---|
| (NG/LP) Vertical Min | 6 |
| (NG/LP) Horizontal Min | 6 |
| (NG/LP) Horizontal Max | 4 |
Heat Shield Requirements
The vertical vent heat shield must be installed for EVERY type of venting
application.
The horizontal vent heat shield must be installed when incorporating minimum
horizontal venting.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>