VIDEX VLF-A105Z LED Portable Flashlight User Manual
- June 9, 2024
- VIDEX
Table of Contents
VIDEX VLF-A105Z LED Portable Flashlight
DESCRIPTION
TECHNICAL PARAMETERS
| TURBO* | HIGH | MIDDLE | LOW | MOON | SOS | ||
|---|---|---|---|---|---|---|---|
| 1 | 1200 Lm | 650Lm | 425Lm | 260Lm | 30Lm | 650Lm | |
| 2 | 1h 30min* | 1h 40min | 2h 30min | 5h 20min | 83h | 1h 40min | |
| 3 | 215m | 156m | 130m | 104m | 35m | 156m | |
| 4 | 11600cd | 6096cd | 4200cd | 2720cd | 312cd | 6096cd | |
| 5 | 5000 K | ||||||
| 6 | LUMINUS SST40, 10W | ||||||
| 7 | Li-ion 18650, 3.7V | ||||||
| 8 | Type-C, 5V 0.8А | ||||||
| 9 | 4 h | ||||||
| 10 | IP44 | ||||||
| 11 | 1 m | ||||||
| 12 | 127х29 mm | ||||||
| 13 | 99 g (without battery) |
- Output.
- Runtime.
- Distance.
- Intensity.
- Correlated color temperature.
- LED type.
- Compatible battery.
- Charging port type, voltage and current.
- Charging time.
- Dust and moisture protection level.
- Impact resistance.
- Product sizes.
- Product weight (without battery).
- Color: black.
- Optical system type: optical lens
- Materials: Aviation anodized aluminum, tempered glass.
Note: Runtime, Distance, Intensity and Charging time results tested with a stock battery Videx 18650 2200mAh. The above mentioned parameters may vary between environments and actual batteries used.
The Turbo mode runtime is the accumulated time, including reduced output levels with the overheat protection enabled.
MAIN FEATURES
- Maximum brightness 1200 lumens in a compact body;
- Tail on/off switch combined with side button for quick modes selection;
- Telescopic focusing mechanism;
- Flux stabilization system prevents fluctuations of brightness.
INCLUDED
- Flashlight VLF-A105Z;
- Li-ion battery Videx 18650 2200mAh;
- Charging cable;
- Lanyard;
- Metal clip
- Spare O-rings;
- User’s manual;
LIGHTING MODES
Turbo – maximum brightness
High – high brightness
Middle – medium brightness
Low – low brightness
Moon – minimum brightness
SOS – emergency signal
OPERATING INSTRUCTION
ON/OFF – press the tail button until it clicks to turn on/off the light;
Modes selection – when the light is switched on, shortly press the side
button to switch between modes cyclically.
SOS mode – when the light is switched on, press and hold the side button
for 3 seconds. Short press again to exit SOS mode.
The flashlight automatically memorizes the last selected lighting mode (except
the SOS mode) and applies it next time when turned on.
BATTERY STATUS INDICATION
The battery status is continuously displayed on the side button, when the
light is turned on.
Continuous green light – 100-80% charge;
Flashing green light – 79-50% charge;
Continuous red light – 49-25% charge;
Flashing red light – critical charge 24-1%.
CHARGING
Plug the USB-A socket of the charging cable into electrical outlet.
Switch off the light, open the protective cover and connect the charging cable
to the flashlight port.
When charging, the indicator glows red. When fully charged, the indicator
glows green.
After a full charge, unplug the charging cable and close the protective cover
to prevent water and dust from entering the flashlight body.
© The original batteries are supplied charged and can be used immediately
after purchase, however it is recommended that the battery be fully charged
before first use. The battery needs to be charged in time before it is
completely discharged. During long periods of storage, it is recommended to
keep the battery charging level at about half capacity to extend its service
life.
BATTERY REPLACEMENT
a) Unscrew the tail part of the flashlight counterclockwise;
b) Insert the battery with the (+) contact towards the head of the
flashlight;
c) Screw the base all the way in and test the flashlight.
MAINTENANCE AND SAFETY INSTRUCTIONS
-
For long-term storage, it is necessary to remove the batteries from the flashlight.
-
It is recommended to regularly lubricate the rubber seals and threaded parts of the flashlight to prevent premature wear and ensure the waterproof housing. If the rubber rings are damaged, they must be replaced.
-
Lock the flashlight to avoid accidental activation during carrying and storage;
-
ATTENTION. Avoid direct light into eyes as it may cause the eyes damage.
-
The flashlight can accumulate a significant amount of heat when used for a long time, which can cause the body to become hot.
Therefore, be careful to avoid burns. -
It is forbidden to shine the flashlight in a critical proximity to easily flammable substances in order to avoid fire.
-
Do not use batteries other than those specified in the technical specifications.
-
Do not disassemble the flashlight head as this may compromise performance and void the warranty.
-
Keep out of the reach of children.
WARRANTY
The warranty for the flashlight is 3 years, for the battery – 1 year.
The warranty does not cover accessories. The LED source inside the flashlight
is not replaceable. If the LED fails, the whole flashlight should be replaced.
During the warranty period, a faulty flashlight and battery can exchanged or
returned with the prove of purchase and all accessories saved.
The following does not apply with the scope of limited warranty:
– Misuse the product and cause the products integral components damage;
– Unauthorized disassemble or the presence of deep mechanical damage to the
product;
– Damage due to force majeure.
ENVIRONMENTAL PROTECTION
Pursuant to the provisions of the WEEE Act, it is forbidden to put waste
equipment marked with the symbol of a crossed bin together with other waste.
The user, wishing to get rid of electronic and electrical equipment, is
obliged to return it to a waste equipment collection point. There are no
hazardous components in the equipment that have a particularly negative impact
on the environment and human health.
The producer shall not be responsible for any damage resulting from the failure to follow above instructions. The producer reserves the right to make updates of this user’s manual.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>