BRAUN 7790 Mens Electric Shaver Instruction Manual

Table of Contents

Our products are designed to meet the highest standards of quality, functionality, and design.
We hope you enjoy your new Braun shaver.
Your Braun Syncro is supplied with a Braun Clean&Renew™ (please see separate use instructions).

SmartLogic

The «SmartLogic» electronics inside your shaver analyze your shaving patterns and then adapt the battery care to ensure optimal performance.

Warning

Keep the appliance dry.
Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply.
Do not exchange or manipulate any part of it. Otherwise, there is a risk of electric shock.

First charging: Using the power supply cord set, connect the shaver to the mains with the switch on position «0» and charge it for at least 4 hours (the plug might get warm). The «SmartLogic» inside your shaver automatically monitors the condition of the batteries as well as the charging/discharging processes and adapts them to your shaving patterns.
From now on, the «SmartLogic» inside your shaver will ensure optimal care of the battery. If, for instance, it is your habit to never let the batteries get low, the «SmartLogic» will recognize this, look for a pause when you are likely to not use the shaver and completely discharge, and then recharge your shaver to recondition the batteries (every six months at the most, and only when necessary).
A full charge will give up to 50 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles
The best environmental temperature range for charging is 15 °C to 35 °C.
Do not expose the shaver to temperatures of more than 50 °C for longer periods.

The pilot light shows that the shaver is connected to the mains.

7790: When the rechargeable battery is fully charged, all five charging lights illuminate (20% per light), provided the shaver is connected to the mains or switched on.
7785/7765: The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light flashes or goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity.
7790/7785/7765: The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves. $BRAUN-7790-Mens-Electric-Shaver-FIG-1 $5$$

Switch positions

Press and push up the switch to operate the shaver:

1 = Shaving with the pivoting head The pivoting cutting system automatically adjusts to every contour of your face
2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e.g. under the nose)
3 = The long hair trimmer is activated (for trimming sideburns, mustache and beard)

Shaving with the cord

If the rechargeable battery is discharged, you may also shave with the shaver connected to the mains via the power supply cord set.
(If the shaver does not run immediately, charge it with the switch on position «0» for approx. 1 minute.)

Tips for the perfect shave

We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of beard growth.
Replace the shaver foil and cutter block every 11/2 years, or when the parts are worn, to ensure optimum shaving performance.

Automated cleaning

The Braun Clean&Renew™ (with 7790 and 7785 models only) automatically takes care of all cleaning and lubrication needs of your shaver.
Please refer to separate use instructions.

For easy cleaning after each shave, switch the shaver off.
Press the release buttons to lift the shaver foil (do not remove the foil completely).
Switch on the shaver for approx. 5-10 seconds so that the shaved stubbles can fall out.
For a thorough cleaning (weekly), remove the shaver foil and tap it out on a flat surface.
Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block with Braun cleaning agents.
If your skin is very dry and you notice a reduced operation time of the shaver, apply a drop of light machine oil onto the shaver foil. $BRAUN-7790-Mens-Electric-Shaver-FIG-1 $8$$

Replacing the shaving parts

To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn.
Change both parts at the same time for a closer shave with less skin irritation.
(Shaver foil and cutter block: 7000 series)

This product contains rechargeable batteries.
In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.
Subject to change without notice.
This product conforms to the European Directives EMC 89/336/EEC and Low Voltage 73/23/EEC.
For electric specifications, see the printing on the special cord set.