LiGHTPRO 213S Juno Tube User Manual
- June 9, 2024
- LiGHTPRO
Table of Contents
LiGHTPRO 213S Juno Tube
Thank you for purchasing the Lightpro Juno Tube. This document contains the required information for correct, efficient and safe use of the product. Consult the general manual of the Lightpro 12-volt system and the user manual of your transformer for more information about the set up and connection of your light plan. Read the information in this manual carefully before using the product. Keep this manual near the product for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Juno Tube is a standing LED lamp for outdoor use. The fixture can be mounted on a solid surface or placed in the ground with the supplied spikes. This product may only be used as outdoor lighting in combination with the Lightpro 12-volt system. Any alterations made to the product may have consequences for the safety, guarantee and correct functioning of the product and/or other parts of the system.
SPECIFICATIONS
- Product Juno Tube
- Article number 213S
- Light source LED 1,5 W AC/DC 12V
- Power (max) 1,5W
- Luminous flux (max) 192 lm
- Light colour 3.000K
- Average lifetime 25.000
- Dimensions (h x Ø) 85 x 55 x 68 mm
- Protection class IP65
- Ambient temperature -20°C to 50°C
- Cable length 3m
- Dimmable No
- Light source Not replaceable
- On/off 10.00
PACKAGING CONTENT
- Juno Tube luminaire
- Friction ring
- Mounting block
- 3A. Adjusting screw
- Cover
- Lightpro connector
- Allen keys
Check if all parts are present in the packaging. For questions about parts, service, and any complaints or other remarks, you can always contact us. E-mail: info@lightpro.nl
MOUNTING SPOT
- Remove the cover cap [4] from the mounting block [3].
- Use the Allen key [6] to turn the adjusting screw [3A] in the mounting block [3].
- Place the friction ring [2] on the mounting block [3].
- Turn the luminaire [1] with the cables as a package on the mounting block until you begin to feel resistance and slide the lamp to the desired position.
- Slide the mounting block [3] to the desired position.
- Secure them at the back with the set screw [3A] and Allen key [6] and place the cover cap [4].
[Figure C]
Route the cable by pushing it into the recess at the back of the tube.
Carefully slide the mounting blocks over the tube when the cable is in the
tube to avoid damaging the cable.
Repeat this step in case more luminaires are mounted.
THE SYSTEM
UK Authorised Representative (for authorities only) ProductIP (UK) Ltd. 8, Northumberland Av. London WC2N 5BY
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>