AAMP P-BUA-TRANSIT CONNECT Wiring Harness for Backup Alarm 2014 to 2022 Ford Transit Connect Instruction Manual

June 9, 2024
AAMP

AAMP P-BUA-TRANSIT CONNECT Wiring Harness for Backup Alarm 2014 to 2022 Ford Transit Connect
AAMP P-BUA-TRANSIT CONNECT Wiring Harness for Backup Alarm 2014 to 2022 Ford
Transit Connect

Thank you for purchasing the

P-BUA-TRANSIT CONNECT

WHAT’S INCLUDED:

  • Vehicle Specific Wire Harness (P-BUA-TRANSIT CONNECT)

COMPATIBLE ACCESSORIES:

  • 97dB Backup Alarm (BUA-97C)

TOOLS REQUIRED:

TOOLS REQUIRED

  1. 10mm Nut-setter
  2. Impact Drill
  3. Panel Removal Tool
  4. Fish Tape
  5. Knife

Instructions for Use

  • STEP 1: Locate and disconnect the OEM tail lamp connector that is in the driver side rear corner of the vehicle

  • STEP 2: Install the P-BUA-TRANSIT CONNECT harness between the OEM connectors

  • STEP 3: Route the harness down the driver side rear corner cavity.

  • STEP 4: Remove the pictured grommet, so that the harness may pass through.
    Use a fish tape to route the 2 pin connector of the harness down through the bottom of the rear corner cavity and below the vehicle

  • STEP 5: Use an impact drill and 10mm nut-setter to install a compatible backup alarm on the underside of the vehicle
    Note: (2) 10mm TEK screws are provided with the compatible backup alarm

  • STEP 6: Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT CONNECT harness. Use a knife to make a small cut in the grommet before it is re-installed

  • STEP 7: Test the backup alarm

Customer Service

Phone – 866-931-8021 (option 3)
E-Mail – support@aampglobal.com
AAMP Commercial is a Power Brand of AAMP Global
aampcommercial.com

AAMP

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

AAMP User Manuals

Related Manuals