AAMP P-BUA-PROMASTER Wiring Harness for Backup Alarm 2018-2021 RAM Promaster Instruction Manual
- June 9, 2024
- AAMP
Table of Contents
AAMP P-BUA-PROMASTER Wiring Harness for Backup Alarm 2018-2021 RAM Promaster
INTRODUCTION
Wiring Harness for Backup Alarm 2018-2021 RAM Promaster
Thank you for purchasing the P-BUA-PROMASTER
WHAT’S INCLUDED
- Vehicle Specific Wire Harness (P-BUA-PROMASTER)
COMPATIBLE ACCESSORIES
- 97dB Backup Alarm (BUA-97C)
TOOLS REQUIRED
- 10mm Nut-setter
-
2 Phillips Bit
- Impact Adapter
- 17mm Socket
- Impact Drill
HOW TO OPERATE
STEP 1: Remove the (7) #2 Phillips screws from the black plastic trim panel that covers the C-pillar cavity and tail lamp connector
STEP 2:
- Unplug the OEM tail lamp connector
- Remove the (2) 17mm fasteners that hold the tail lamp assembly in place
STEP 3:
Plug the OEM tail lamp connector into the male end of the P-BUA-PROMASTER harness
STEP 4:
Use an impact drill and 10mm nut-setter to install a compatible backup alarm
behind the tail lamp assembly. The backup alarm should be mounted high, so
that it clears the tail lamp assembly when it is re-installed.
Note: (2) 10mm TEK screws are provided with the compatible backup alarm
STEP 5:
Plug the backup alarm connector into the mating connector on the P-BUA-
PROMASTER harness
STEP 6:
- Place any excess harness into the C-pillar cavity
- Re-install the tail lamp assembly
- Re-install the black plastic trim panel
STEP 7:
Test the backup alarm
Phone – 866-931-8021 (option 3)
E-Mail – support@aampglobal.com
AAMP Commercial is a Power Brand of AAMP Global
aampcommercial.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>