AAMP Commercial P-BUA-TRANSIT Wiring Harness for Backup Alarm Instruction Manual
- June 12, 2024
- AAMP Commercial
Table of Contents
AAMP Commercial P-BUA-TRANSIT Wiring Harness for Backup Alarm
Thank you for purchasing the P-BUA-TRANSIT
WHAT’S INCLUDED:
- Vehicle Specific Wire Harness (P-BUA-TRANSIT)
COMPATIBLE ACCESSORIES:
- 97dB Backup Alarm (BUA-97C)
TOOLS REQUIRED:
- 10mm Nut-setter
- T-25 Torx Bit
- Diagonal Cutters
- Impact Drill
INSTALLATION INSTRUCTIONS
STEP 1:
Remove the (2) T-25 torque fasteners that are holding the tail lamp in place.
STEP 2:
- Unplug the OEM tail lamp connection.
- Install the P-BUA-TRANSIT harness inline between the two OEM tail lamp connectors.
STEP 3:
Route the harness down through the bottom of the tail lamp opening, behind the bumper skin, and below the vehicle.
STEP 4:
Use an impact drill and 10mm nut-setter to install a compatible backup alarm beneath the driver side rear corner of the vehicle.
Note : (2) 10mm TEK screws are provided with the compatible backup alarm.
STEP 5:
Use the provided p-clamps and self tapping screws to secure the harness to the underside of the vehicle.
STEP 6:
Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT harness.
STEP 7:
Re-install the tail lamp assembly and test the backup alarm.
CUSTOMER SUPPORT
Phone – 866-931-2021(option 3)
E-Mail – support@aampglobal.com
AAMP Commercial is a Power Brand of AAMP Global
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>