UltraLux MSD2460D Dual Function IR Double Sensor Instruction Manual
- August 13, 2024
- ULTRALUX
Table of Contents
MSD2460D Dual Function IR Double Sensor
Instruction Manual
THE INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED ELECTRICIAN ACCORDING TO THIS MANUAL. PLEASE KEEP THE INSTRUCTIONS.
TECHNICAL SPECIFICATIONS
Voltage: | 12/24 V DC |
---|---|
Rated load: | 60 W |
Detections distance: | 5 cm |
Detection range: | 10° |
Cable length: | 2 x 1000 mm |
IP rate: | IP20 |
https://www.ultralux.bg/downloads/upotreba/Instruction-MSD2460D- web.pdf
DESCRIPTION
The product consists of a small controller with 2 infrared sensors. There are
two modes of operation, which are changed via a button located on the housing.
PROXIMITY SENSOR MODE: The sensors detect position of moving objects (doors,
drawers). If an obstacle occurs within the range of both sensors (both cabinet
doors closing simultaneously), the controller will turn off the LED lighting.
If the obstacle disappears within the range of one of the sensors (opening of
one of the two cabinet doors), the controller will switch on the LED ighting.
The main application of the product is automation offurniture LED ighting
(cabinets, wardrobes, shelves, drawers, buffets, etc.).
PROXIMITY SWITCH MODE: The sensors detect moving objects. When there is a
single brief movement (hand wave) within range of one of the sensors, then the
controller will turn on the LED lighting. When motion (hand wave) occurs again
within range of one of the sensors, the controller will turn off the LED
lighting.
Note: After a power outage and its restoration, the furniture IR sensor
in “PROXIMITY SWITCH MODE” always starts with the LED lighting turned off.
SAFETY INSTRUCTIONS
- Performing any actions while electrical voltage s present carries the potential risk of electric shock. The power supply must be disconnected before starting any work.
- Before replacement, disconnect from the electrical grid.
- The installation should be carried out in accordance with the current nstructions by a qualified professional.
- All conductors and fitting auxiliary components are to be placed at an appropriate distance from the heating parts of the fitting. When choosing the place for mounting, the required minimum distance must be kept between the fitting and the lightened objects.
- The sensor s designed for installation in indoor environment and must be used in places with normal evels of humidity and dust- lP20 protection rating.
- The manufacturer bears no responsibility for damages resulting from failure to comply with these instructions.
RECESSED INSTALLATION
- Drill 2 holes with a diameter of 08 mm and a depth of 20 mm, then place the sensors into it.
- Drill a hole with a diameter of 010 mm and pass the connecting wires of the sensors through it.
- Connect the OUTPUT connector to the load (LED lighting) and connect the INPUT connector to the power supply for the LED lighting.
SURFACE INSTALLATION
- Mount the surface mounting brackets.
- Drill a hole with a diameter of 010 mm and pass the connecting wires of the sensors through it.
- Connect the OUTPUT connector to the load (LED lighting) and connect the INPUT connector to the power supply for the LED lighting.
WIRING DIAGRAM TAKING CARE OF THE NATURAL ENVIRONMENT CLEANLINESS
The product and its components are not harmful to the environment. Please
dispose the package elements separately n containers for the corresponding
material.
Please dispose the broken product separately n containers for out of usage
electrical equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>