NIGHTSTICK USB-4510 Elastic Strap Instruction Manual

NIGHTSTICK USB-4510 Elastic Strap

WARNINGS

• NOT FOR USE ABOVE HAZARDOUS LOCATIONS
• DO NOT use in explosive atmospheres, near flammable liquids, or where explosion proof lamps are required.
• DO NOT use in the proximity of vehicles or equipment when there is a risk of flammable liquids coming into contact with the flashlight.
• DO NOT expose the battery to water or salt water, or allow the battery to get wet.
• Keep out of the reach of children.

CHARGING THE LIGHT

CHARGER INPUT: 5 VDC Max WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TO CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE PERFORMED IN AN AREA KNOWN TO BE NON- HAZARDOUS.
Fully charge the light before the first use, or if the battery is new or has been unused for several months. For best performance, charge the light when the headlamp beam starts to dim.

• Use only the supplied Nightstick USB cable.
• Locate the USB port on the side of the headlamp, remove the rubber USB port cover, and plug the USB cable into the headlamp’s USB port.
• The total time to full charge varies depending on the remaining charge in the battery pack.
• When the USB cable is connected, the charging indicator lights on the top will glow red while the light is charging and then turn green when it is fully charged. When the cable is disconnected, the charging indicator lights will turn off

OPERATION

OPERATION

The two switches control all functions on the headlamp. The below instructions apply while wearing the headlamp.

WHITE FLOODLIGHT SWITCH – RIGHT SIDE

• Press and release to turn the floodlight to low-brightness.
• Press quickly a second time (within 1.5 seconds) to change the floodlight to high-brightness.
• Press and release from any mode after it has been on for more than 1.5 seconds to turn the floodlight off.

RED/GREEN FLOODLIGHT SWITCH – LEFT SIDE

• Press and release to turn the red floodlight on.
• Press quickly a second time (within 1.5 seconds) to change the floodlight to green.
• Press and release from any mode after it has been on for more than 1.5 seconds to turn the floodlight off.

BATTERY SHUT OFF MODE

• Press and hold both switches at the same time for 3 seconds to enable or disable battery shut off mode.
• After three seconds the white floodlight will flash on and off 1 time to confirm a change in the battery safe mode.
  NOTE: The battery safe mode reverts to disabled when battery is fully discharged.

PSA MOUNTING INSTRUCTIONS

• Ensure mounting surface is clean and oil-free. Use included alcohol wipe to clean the surface.
• Determine best location that does not interfere with brim.
• Remove adhesive backing.
• Firmly press mount into place and hold for 30-60 seconds.

IMPORTANT: WAIT 24 HOURS FOR ADHESIVE TO REACH MAXIMUM STRENGTH

WARRANTY

2 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and materials to the original purchaser for 2 years from the date of purchase, and includes the LEDs, housing, lenses, electronics, switches, rechargeable batteries and chargers. Bulbs (other than LEDs) are covered for 90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective. This
is the only warranty, expressed or implied, including any warranty of merchantability or fitness for a particular purpose For a complete copy of the warranty, go to www.baycoproducts.com/baycoproduct- support/warranties. Retain your receipt for proof of purchase.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>