DETEX 101998 Outside Lever Pull Trim Instruction Manual

June 4, 2024
DETEX

DETEX 101998 Outside Lever Pull Trim

DETEX 101998 Outside Lever Pull Trim

TOOLS AND SUPPLIES

  • Safety Glasses

(Always put on safety glasses prior to beginning installation of unit)

  • Pencil
  • Center Punch
  • Hammer
  • Drill Motor
  • Drill Bits 8& Taps
  • Screw Driver (Phillips Drive)
  • Tape Measure

WARRANTY

For WARRANTY information, scan code below or go to www.detex.com/warranty

Device installation

For device installation videos, scan code below or go to www.detex.com/videos

LEFT-HAND REVERSE ASSEMBLY SHOWNDETEX 101998 Outside Lever Pull Trim
3 DETEX 101998 Outside Lever Pull Trim
4

INSTALLATION

  • STEP 1: PREP DOOR
    • Use plastic template to mark TRIM holes (LHR shown)DETEX 101998 Outside Lever Pull Trim 7

NOTE: The height from the finished floor to the trim/device centerline that Detex recommends is 40″.

  • *       * If unsure of trim/device centerline location, use the method below and at right to determine correct trim location.
    • STEP 2: INSTALL TRIM & BACKPLATE
      Install backplate with four 1/4-20 x 1″ long screws and lockwashers provided with exit device

    • STEP 3: INSTALL MORTISE LOCKDETEX 101998 Outside Lever Pull Trim 9

Note: Mortise lock and mounting hardware supplied with exit device. Fasten screws loosely.

IMPORTANT!
For modular cable devices, see electrical instructions for cable routing.

MARK & DRILL HOLES – TRIM SIDE:

Mortise lock NOT supplied with TRIM. For a retrofit application, remove lock and exit device before installing new trimDETEX 101998 Outside Lever Pull
Trim 5

Change Handing (if required) (Place trim on a clean surface with this view facing up)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals