DETEX 101898 Outside Trim Instruction Manual
- June 4, 2024
- DETEX
Table of Contents
DETEX 101898 Outside Trim
TOOLS AND SUPPLIES
Safety Glasses
(Always put on safety glasses prior to beginning installation of unit)
Pencil
Center Punch
Hammer
Drill Motor
Drill Bits & Taps
Screw Driver (Phillips Drive)
Tape Measure
For WARRANTY information,
scan code below
or go towww.detex.com/warranty
For device installation videos,
scan code below
or go towww.detex.com/videos
OVERVIEW
ITEM | PART NO. | QTY | PART NO. QTY DESCRIPTION |
---|---|---|---|
1 | 101911-9 | 1 | TRIM PLATE, 01W, BRUSHED STAINLESS STEEL FINISH (630) |
1 | 4 | SEX NUT, 1/4-20 |
STEP 1: PREP DOOR
MARK & DRILL HOLES – TRIM SIDE
Use plastic template to mark TRIM holes (LHR shown)
NOTE: The height from the finished floor to the trim/device centerline that
Detex recommends is 40″.
If unsure of trim/device centerline location, use the method below and at right to determine correct trim location.
STEP 2: INSTALL TRIM
STEP 3: INSTALL MORTISE LOCK
Note: Mortise lock and mounting hardware supplied with exit device. Fasten
screws loosely
**TRIM INSTALLATION COMPLETE**
Continue installation using device instructions
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>