DETEX Mortise 01CM Outside Trims Instruction Manual
- June 4, 2024
- DETEX
Table of Contents
DETEX Mortise 01CM Outside Trims
PRODUCT DESCERIPTION
ITEM | PART NO. | QTY | DESCRIPTION |
---|---|---|---|
1 | 102219-9 | 1 | TRIM PULLPLATE, 01, (BLANK), BRUSHED STAINLESS STEEL FINISH |
(630)
102218-9| TRIM PULLPLATE, 02 (W/PULL), BRUSHED STAINLESS STEEL FINISH (630)
2
| 102271-116| ****
1
| SCREW, MACH, 1/4-20 X 1″, PFH, STAINLESS STEEL (01)
102271-136| SCREW, MACH, 1/4-20 X 2-1/4″, PFH, STAINLESS STEEL (02)
102271-144| SCREW, MACH, 1/4-20 X 2-3/4″, PFH, STAINLESS STEEL (02)
3| 102272-2| 1| WASHER, #14, FINISHED, STAINLESS STEEL
4| 102235-9| 1| PULL, 02C
5| 102264-1| 1| SCREW, MACH, 1/4-20 X 1/2″ UNDERCUT, PFH (02)
INSTALLATION
STEP 1: PREP DOOR
MARK & DRILL HOLES – TRIM SIDE:
Use plastic template to mark TRIM holes (LHR shown)
NOTE: The height from the finished floor to the trim/device centerline
that Detex recommends is 40″.
If unsure of trim/device centerline location, use the method below and at
right to determine correct trim location.
STEP 2: PREP & INSTALL TRIM
Note: Steps 2A through 2C are for 02CM (trim with pull) installation. For 01CM (trim without pull) installation, skip to step 2D
TRIM INSTALLATION COMPLETE
Continue installation using device instructions