KUZCO EP64810 Parc Outdoor Pendant Instruction Manual
- June 9, 2024
- KUZCO
Table of Contents
KUZCO EP64810 Parc Outdoor Pendant
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- Must be installed on a covered ceiling
- 120V input
Technical Support: 1-855-855-8926
INSTALLATION INSTRUCTION
- Remove fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing set screws (2f)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package
- Determine hanging height of fixture by securing rods (2d) to canopy (2a) and fixture body (3a) after feeding fixture wires (LED+ and LED-) through rods
- Make proper electrical connections between LED and DC driver, LED- Negative, LED+ Positive using quick connector provided (See Illustration 1 and refer to diagram on driver)
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and then place driver (4a) inside junction box (1a)
- Attach canopy (2a) to mounting plate (1c) with set screws (2f)
19054 28th Avenue Surrey,
BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO
F: 604 538 7196
W: kuzcolighting.com
20220427
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>