BLNAN CL-G36W-DIM-WY Dimmable Ceiling Light User Manual
- June 9, 2024
- BLNAN
Table of Contents
IBLNIANI® DIMMABLE CEILING LIGHT
User Manual
CL-G36W-DIM-WY
INTRODUCTION
Dear customer,
Thank you for purchasing our ceiling light. In order to use this product
correctly, please read and keep this instruction for future reference.
If you have any questions, please contact the following
Email address: support@blnan.net
PRODUCT INTRODUCTION
The product is a dimmable LED ceiling light.
You could directly use the remote control to set the functions. We are
dedicated to the customers to bring a convenient and comfortable experience.
SPECIFICATIONS
Size | c$39025mmAp15.350.99in |
---|---|
Wattage | 36W |
Voltage | AC120V 60Hz |
Luminous Flux | 3600LM |
Color Temperature | 3000K-6500K |
LED Quantity | 180 PCS |
LED Type | 2835 |
CRI | 90 |
Material | PC |
Waterproof | IP40 |
Remote Control Frequency | Infrared |
Life Span | 30000H |
IR REMOTE CONTROL OPERATION INSTRUCTIONS
- 0N/OFF
- Turn off the light after 30 seconds
- Steplessly up to 100% brightness
- Steplessly down to 10% brightness
- Steplessly down to 3000k
- Steplessly up to 6500k
- Natural white: 4000k
- Night light mode
- Change to 50% brightness
- Different Color temperature cycle
- Warm white: 3000k
- Cold white: 6500k
NOTE:
- The infrared remote control, need to be aimed at the light.
- The remote control distance is 3-5 meters.
- You can change the color temperature(cast Settings/4000K/3000K/6500K) by continuously turning on and off (within 5 seconds).
- Memory function: the current color temperature and brightness will be saved after 1 minute. Next time you turn on the light, the light will still be the same.
- The color temperature can be changed by the wall switch. (Do not fit for home dimmer! )
- Brightness only can be adjusted by remote control, not by wall switch.
ACCESSORIES LIST
INSTALLATION STEPS
- Rotate and remove the base plate, fix the base plate to junction box with screws(provided)
- Please use the correct size junction box. The screw hole distance of the junction box: 2.75-5.4 inches.
- Hang up the wire rope and connect the wires of the corresponding color, then push and feed all wires up into junction box. (Description of the supply terminals: Black: Hot Wire,White: Naught Wire, Green: Ground Wire)
- Push and rotate the lamp and install onto base plate.
PRECAUTIONS
Precautions Before Installation:
- Power off before installation.
- Do not exceed the rated voltage.
- Do not install it on the surfaces where are not stable or deformed.
- Do not install it on or above the surface with high temperature.
- Please make sure that no gas, water or electricity pipes and wires can be drilled through or damaged in your chosen mounting location.
Precautions During Installation:
- There must be no corrosive, explosive or flammable materials around the lamp.
- User should connect the cable correctly, and the lamp should be installed by qualified electrician.
- Please pay attention to connect the wires correctly, and make sure the cable connection comply with national regulations.
- Please make sure that the lampshade is clear in case of low luminous efficiency.
- Please make sure that illuminants are securely fixed during the installation.
Precautions About the Product:
- 1t is not suitable for dimmers and electronic switches.
- The LED light source inside the lamp body can not replaceable.
- The lampshade cannot be opened.
- Do not look straight into the light source (illuminant, LED, etc.).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>