GP CWP15 Panel Light Instruction Manual
- June 4, 2024
- GP
Table of Contents
Instruction Manual
CWP15 Panel Light
| 
---|---
Charging the panel light
- Remove the waterproof cover and plug the provided USB-C charging cable into the USB-C port.
- Connect the USB-A end of the cable to a power source such as a USB power adapter, power bank, or computer.
- The panel light is fully charged when all battery indicators are lit.
- Disconnect the USB-C cable from the panel light and re-insert the waterproof cover.
Battery indicators
Battery power capacity
Charge status
Operation
- Press the On/Off button to cycle through the 3 brightness settings: Low – Medium – High – Off
| ANSI FL1 Standard | High | Medium | Low |
|---|---|---|---|
| Lumens | 1200 lumens | 700 lumens | 250 lumens |
| Candela | 494cd 210cd | 210cd | 100cd |
| Beam distance | 45m | 29m | 20m |
| Runtime IP Rating | 4.5h 7h | 7h | 17.5h |
| IP Rating | IPX7 | ||
| Impact resistance | 1.5 m |
Battery details
- Built-in 3.6V Li-Ion battery (5100mAh)
- Charging time: 5 hours
Usage and Care
- Do not dismantle the product, as this can cause harm to the product and the person will void the warranty.
- This has a high lumen output so be careful not to shine directly into anyone’s eyes as it may cause harm and injury.
- Do not cover the product when in operation to avoid excessive heat accumulation.
- The battery is sealed and cannot be replaced for your own safety.
- Do not use cleaning agents that may damage the product. Use a soft cloth to avoid scratching.
- This product uses a sealed Li-ion 18650 battery. Always connect the USB carefully to avoid water and other liquids getting into the port, which may cause damage to the unit and batteries.
- Please charge every 3 months if not used to maintain battery longevity.
- Do not leave the panel light on permanently charge status as this can cause battery damage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>