GOLDEN LIGHTING 0846-6SF Lillianne 6 Light 29 Wide Semi Flush Ceiling Fixture Installation Guide
- June 13, 2024
- GOLDEN LIGHTING
Table of Contents
GOLDEN LIGHTING 0846-6SF Lillianne 6 Light 29 Wide Semi Flush Ceiling
Fixture
Thank You for Choosing Golden Lighting for Your Lighting Needs!
Product Information
- Model: 0846-6SF
- Fixture Type: Pendants & Chandeliers
- Usage: Suitable for installation above a kitchen island, dining room table, or in open areas
Installation:
Requires wiring and mounting to the ceiling
Product Usage Instructions
- Pendants & Linear Pendants Above a Kitchen Island:
- Center a linear pendant over the island.
- If using hanging pendants, use one pendant for every 24 inches of island.
- Fixtures should hang at least 30 inches above the countertop.
- Pendants & Chandeliers Above a Dining Room Table:
- Fixtures should stay at least 30 inches above the table.
- Use a fixture that is 12 inches narrower than the width of the table.
- Pendants and Chandeliers in Open Areas:
- The bottom of the fixture should hang at least 7.5 feet from the floor.
- Allow clearance for any opening doors.
- General Tips for Lighting in Your Space:
- Layer your lighting to have both task and ambient lighting.
- Coordinate fixtures like sconces, flush mounts, and pendants to meet your layered lighting needs.
- Install lights with dimmers to control the level of light output.
Assembly Instructions
-
Preparing for Installation:
- Ensure you have all the necessary parts and tools.
- Contact the place of purchase for replacement parts if needed.
Carefully remove the new fixture from the carton as well as the yellow bag that holds all of the parts. See the important notes above. Shut off power at the circuit breaker and remove old fixture from wall, including the old mounting strap. 1. Mounting strap (B) contains several threaded holes. Two sets of mounting screws (A & C) should be attached to mounting strap (B). 2. Pull the house wires through the center of mounting strap (B). Place mounting strap (B) over the junction box. Use a screwdriver to secure mounting strap (B) to the junction box with mounting screws (C).
-
Assembling the Fixture:
- Feed the fixture’s wires from the nipple (G) through the decorative column (F).
- Push the wires through the hole in the decorative column (F) until it comes out the end where the top is attached.
- Pull the wires until taut.
- Thread column (F) onto nipple (G) to secure the column and piece to the fixture.
- Pull the wires until taut.
- Adjust the 6pcs arms (H) to a uniform distribution.
-
Connecting the Wires:
- Follow the instructions for connecting the fixture wires to the house wires.
- Match the corresponding wires: Hot to Hot, Neutral to Neutral, Ground to Ground.
Have an assistant support the fixture’s weight while completing the wiring. Refer to the wiring diagram and attach the fixture’s wires to the power supply wires from the junction box. Attach the fixture’s wires to the power supply wires from the junction box. Connect Hot to Hot (transparent wire with black inner thread, black, or smooth wire) Neutral to Neutral (transparent wire with white inner thread, white, or ribbed wire), and Ground to Ground (transparent wire with green inner thread, green wire, or copper). Twist the ends of the wire pairs together, and then twist on a wire connector. Make sure all twists are in the same direction. If there is no house ground wire coming from the junction box, locate ground screw (E) on the mounting bracket/mounting strap and wrap the fixture’s ground wire around the ground screw. Use a screwdriver to tighten the top of ground screw (E) onto the wires and into the mounting bracket/mounting strap. Tuck the wires into the junction box.
-
Finishing the Installation:
- Push the ceiling pan (D) up against mounting strap (B).
- Use side screws (A) to secure ceiling pan (D) to mounting strap (B).
- Rotate the leaf assembly (J).
- Install light bulbs (not provided) into sockets (I) according to the fixture’s specifications.
- Do not exceed the maximum recommended wattage.
- Turn on the power and test the fixture. For any further assistance, quick tips, or curated content, visit GoldenLighting.com.
Pendants & Linear Pendants Above a Kitchen Island
Center a linear pendant over the island. If hanging pendants, use one pendant
for every 24″ of island. Fixtures should hang at least 30″ above the
countertop.
Pendants & Chandeliers Above a Dining Room Table
Fixtures should stay at least 30″ above the table. Use a fixture that is 12″
narrower than the width of the table.
Pendants and Chandeliers in Open Areas
The bottom should hang at least 7.5 feet from the floor. Allow clearance for
any opening doors.
We appreciate your business and hope you love your new light!
Great lighting can add value and enhance the look of your home. To ensure the
best lighting in your space, remember to layer your lighting. This ensures
that your space will have both task and ambient lighting. Coordinating
fixtures like sconces, flush mounts, and pendants can help you meet your
layered lighting needs and reinforce your desired aesthetic. Install the
lights with dimmers that allow you to control the level of light output at any
given moment. Get function and style! Browse our site for coordinating lights
and expert lighting advice. To help create the perfect look, visit
www.GoldenLighting.com.
How to Identify the Fixture’s Wires
Hot: Smooth, Black, or Transparent with Black Inner Thread
Neutral: Ribbed, White or Transparent with White Inner Thread
Ground: Copper, Bare Metal, Green, or Transparent Inner Thread
Get help, quick tips, and explore curated content
For Customer Service, contact the place of purchase to arrange for replacement
parts.
IMPORTANT:
- All installation work should be done by accredited professional.
- Shut off power supply at fuse or circuit breaker!
- Use only the specified bulbs. Do not exceed the maximum wattage!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>