JBL Free Wireless Earbuds User Guide

JBL Free Wireless Earbuds

What’s in the box

Warranty card, Warning card, Safety sheet, QSG

Customize your fit

• Mix and match ear tips and silicone sleeves for a perfect fit and audio performance.
• Installation

Wireless Device Pairing

First time pairing with the device

• Step 1 – Ensure that the earpieces a full charge before initiating pairing.
  • Ear pieces and charging cases are packed separately.
• Step 2 – Remove the right earpiece from case, it will turn on automatically, entering pairing mode (alt. blue/white).
• Step 3 – From the device, go to the Bluetooth menu.
• Step 4 – Remove left earpiece from the case, it will automatically connect with the right earpiece.
  • From second time onwards: Wireless connections are automatically established when the headphones are taken out of the case.
  • Ear pieces automatically power off and recharge when put in the charging case.
  • To turn on earpieces manually, long press the button on the earpiece for 5s.

Buttons

Charging

Manual controls for special situations

Manual Bluetooth pairing to the device when earpieces do not pair automatically.

• Step 1 – Long press (>8s) right earpiece button when powered off
• Step 2 – Choose JBL Free
• Manual pairing of left and right earpieces when the connection is lost.
• Manual power off.

LED Behaviors

Charging case : LED behavior

Warning: Switch off the charging case when not in use to avoid battery damage.

SPECIFICATION

• Model: JBL Free X
• Bluetooth version: 4.2
• Support: A2DP V1.3, AVRCP V1.5, HFP V1.6
• Headset Battery type: Lithium-ion polymer (3.7V, 85mAh)
• Bluetooth transmitter power < 9.5dBm
• Bluetooth transmitter frequency range : 2.402 – 2.480GHz
• Bluetooth transmitter modulation : GFSK, π/4 DQPSK, 8DPSK
• Dynamic drivers: 5.6mm
• Frequency Response: 10Hz – 22 KHz
• Charging case battery : 1,500 mAH (est)
• Earbuds Battery life : Up to 4 hours
• Charging time: < 2 hours
• Compatibility: Use with Phones, Tablets, Computers
• Weight : 99g

IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaging over one gram of tissue. Device types: (IC: 6132A-JBLFREEX) has also been tested against this SAR limit According to this standard, thehighest SAR value reported during product certification for head use is 0.033W / kg. The device was tested for typical bodily operations where the product was kept 5 mm from the head. To maintain compliance with IC RF exposure requirements, use accessories that maintain a separationdistance of 0mm between the user’s head and the back of the headset. The use of belt clips, holsters, and similar accessories shall not contain metal parts in its assembly. The use of accessories that do not meet these requirements may not comply with IC RF exposure requirements and should be avoided.

Head operation
The device was subjected to a typical head manipulation test. In order to comply with RF exposure requirements, a minimum separation distance of 0 cm must be maintained between the user’s ear and the product (including the antenna). Head exposure that do not meet these requirements may not meet RF exposure requirements and should be avoided. Use only the supplied or approved antenna.

IC: 6132A-JBLFREEX

FCC STATEMENT

FCC AND IC STATEMENT FOR USERS
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. CAN ICES-3 (B) / NMB-3 (B).

FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, ACCORDING TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED BY THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:

• REORIENT OR RELOCATE THE RECEIVING ANTENNA.
  INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.

• CONNECT THE EQUIPMENT TO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.

• CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.

INSTRUCTIONS FOR USERS ON REMOVAL, RECYCLING, AND DISPOSAL OF USED BATTERIES
FOR PRODUCTS WITH A BUILT-IN BATTERY THAT LASTS FOR THE LIFETIME OF THE PRODUCT, REMOVAL MAY NOT BE POSSIBLE FOR THE USER. IN THIS CASE, RECYCLING OR RECOVERY CENTERS HANDLE THE DISMANTLING OF THE PRODUCT AND THE REMOVAL OF THE BATTERY. IF, FOR ANY REASON, IT BECOMES NECESSARY TO REPLACE SUCH A BATTERY, THIS PROCEDURE MUST BE PERFORMED BY AUTHORIZED SERVICE CENTERS. IN THE EUROPEAN UNION AND OTHER LOCATIONS, IT IS ILLEGAL TO DISPOSE OF ANY BATTERY WITH HOUSEHOLD TRASH. ALL BATTERIES MUST BE DISPOSED OF IN AN ENVIRONMENTALLY SOUND MANNER. CONTACT YOUR LOCAL WASTE-MANAGEMENT OFFICIALS FOR INFORMATION REGARDING THE ENVIRONMENTALLY SOUND COLLECTION, RECYCLING AND DISPOSAL OF USED BATTERIES.

WARNING: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. TO REDUCE THE RISK OF FIRE OR BURNS, DON’T DISASSEMBLE, CRUSH, PUNCTURE, SHORT EXTERNAL CONTACTS, EXPOSE TO TEMPERATURES ABOVE 60°C (140°F), OR DISPOSE OF IN FIRE OR WATER. REPLACE ONLY WITH SPECIFIED BATTERIES. THE SYMBOL INDICATING ‘SEPARATE COLLECTION’ FOR ALL BATTERIES AND ACCUMULATORS SHALL BE THE CROSSED- OUT WHEELED BIN SHOWN BELOW:

IN CASE OF BATTERIES, ACCUMULATORS AND BUTTON CELLS CONTAINING MORE THAN 0.0005% MERCURY, MORE THAN 0.002% CADMIUM OR MORE THAN 0.004% LEAD, SHALL BE MARKED WITH THE CHEMICAL SYMBOL FOR THE METAL CONCERNED: Hg, Cd, OR Pb RESPECTIVELY. PLEASE REFER TO THE BELOW SYMBOL:

WARNING

• DO NOT ATTEMPT TO OPEN, SERVICE, OR DISASSEMBLE THE BATTERY | DO NOT SHORT CIRCUIT | MAY EXPLODE IF DISPOSED OF IN FIRE | RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE | DISPOSE OR RECYCLE USED BATTERIES ACCORDING TO THE INSTRUCTIONS
• www.anatel.gov.br
• The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

References

• Anatel — Agência Nacional de Telecomunicações

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>