rombica BT-S013, BT-S014 Bluetooth Speaker User Manual

BLUETOOTH SPEAKER

mysound Lira Gray ID: BT-S013
mysound Lira Black ID: BT-S014

USER MANUAL

Thank you for purchasing Rombica device.
Please read this user manual before the operation and save it for the future

GENERAL INFORMATION

1. Button «Vole» – increasing volume

2. Button «Powen»
   Long press – power on/off
   Short Press – pause/play
   Quick double press – disconnect of Bluetooth connection (Bluetooth mode)
   Short press during incoming call – receive incoming call (Bluetooth mode)
   Long press during incoming call – reject incoming call (Bluetooth mode)

3. Button «Vol-» – decreasing volume

4. LED indicator

5. Microphone

6. AUX

7. Micro-USB port for charging built-in battery

8. Stereo dynamics

SPECIFICATION

Power: DC 5V, from battery
Bluetooth version: v 4.2
Frequency range: 100 Hz – 18 kHz
Speaker power 12 W (2 x 6 W, RMS)
Speaker diameter: 40 mm
Passive radiator: built-in
Battery: 3000 mAh / 3.7 V
Interfaces: micro-USB, AUX, BT, mic

OPERATION OF THE DEVICE

POWER ON
Press and hold power button. Sound notification and turned-on LED indicator will confirm power on

POWER OFF
Press and hold power button. Sound notification and turned-off LED indicator will confirm power off

PARING VIA BLUETOOTH

1. Disconnect AUX cable if connected. Turn on the speaker.
2. Open Bluetooth settings on your smartphone/PC, enable Bluetooth and search for new devices. When Bluetooth speaker will be found, confirm paring.
3. After successful pairing both the Bluetooth speaker and your device, you can control playback by your device

PHONE CALLS
You could receive incoming calls with Bluetooth speaker if it paired to smartphone/tablet PC.
You can talk using built-in mic and dynamic. Short press «Power» button to receive the incoming call. Press button again to end the call. Long press «Power» button is rejecting incoming call

AUX PLAY
Use (supplied) cable and connect it to the Bluetooth speaker by one side (AUX port) and the external device by another side. Be sure that cable is well connected. The Bluetooth speaker will automatically switch in AUX mode.

BATTERY CHARGING
Before use, fully charge Bluetooth speaker within 8 hours. New battery requires 2-3 full charge-discharge cycles to reach full capacity. Use (supplied) cable and connect it to the Bluetooth speaker by micro-USB side. Connect USB cable to the PC or wall charger (wall charger is not supplied). LED indicator turns red while charging. When LED indicator stops being red – charging is complete

STORAGE CONDITIONS

Keep the device in a dry, well-ventilated place, far from heaters and direct sunlight. Keep the device out of reach of children. Do not bite or lick the device, as it may cause damage or explode the device. Children or persons with disabilities should not use the device without supervision of the responsible person

TECHNICAL CHARACTERISTICS AND APPEARANCE MAY BE CHANGED WITHOUT PRIOR NOTICE

SAFETY INFORMATION

1. Before charging be sure that voltage of the power is 5V.
   The recommended adapter is 5V / 1000mA

2. If device is not used during long time, charge it at least once per month

3. In cause of breaking do not try to open and repair device by yourself. Use service center

4. Avoid influence of the high humidity, dust and dirt. Use dry soft lint-free cloth to clean device. Not allowed to use washing or cleaning liquids

5. Do not store, use or charge device near heat sources and flammable objects, during low or high ambient temperature. Charing can be done only under adult supervision. Recommended temperature is 5 to 35 °C

6. Not allowed to drop or hit device

7. Do not insert foreign objects to the device interfaces

8. Turn off device after use

9. Never pull the cord to disconnect cable, pull the plug

10. Bluetooth speaker is not intended for the commercial use

11. Standard battery life is 500 charge-discharge cycles. After exceeding 500 cycles the effective capacity of the battery can be reduced. Effective capacity also depends on the ambient temperature

12. Do not cover working device by cloth or other material

IN THE BOX

1. Bluetooth speaker
2. USB cable
3. AUX cable
4. Rope

Do not dispose with household waste! Required to dispose this electrical device at designated recycling collection point for electrical devices. It ensures that device is recycled professionally and prevents the release of the harmful substance into the environment. Make sure that device is uncharged before disposal

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>