rombica DL-A001 Portable Silicone LED Lamp User Manual
- June 8, 2024
- rombica
Table of Contents
rombica DL-A001 Portable Silicone LED Lamp
IN THE BOX
- Portable Silicone LED Lamp
- Micro-USB cable
- User manual
GENERAL INFORMATION
SPECIFICATION
- Input: 5V/0.5A
- Body material: Silicone
- Built-in battery type: Li-ion
- Battery capacity: 1200 mAh/4.44 Wh
- MAX power up to”: 0.80OW (white) 0.84W (color)
- Working time: Up to 24 hours (white) Up to 12 hours (color)
- LED’s lifetime: up to 30000 hours
- Size: LED Rabbit: 110 x 130 x 187 mm LED Bear: 110 x 120 x 153 mm
HOW TO CHARGE
- Turn off LED Lamp and insert provided micro-USB cable into respective port of the LED Lamp.
- Plug USB port of the cable into USB port of your PC or wall charger (not provided).
- LED indicator turns red during charging. When LED indicator turns green-charging is complete.
HOW TO USE
- Power ON/OFF: press the Power button.
- How to switch operating modes: Mode #1 activates when the power is turned on.
- To change operating mode slap the device’s body.
OPERATING MODES
- Continuous white light.
- Continuous white light (MAX brightness).
- Gradient color change
- Sequential color change: red-yellow – purple – green-light blue-orange- blue -pink.
- Continuous color light (active color when mode was changed from #4 to #5).
- Turning off LED lights: if operating mode is not changed in 10-20 minutes, LED Lamp automatically turns off.
SAFETY INFORMATION
- Charge the device’s battery for 12 hours before first use. To achieve maximum battery capacity it is necessary to charge-discharge it for 2-3 times.
- Before charging ensure that supplied voltage is equal to 5V. Recommended wall charger parameters are 5V/500mA.
- T device is not used tor a long time, charge it at least once per month.
- The standard cycle life of the battery is 500 charge-discharge cycles. After exceeding this number battery capacity may decrease.
- Before charging the device be sure that you use USE- micro-USE cable. Using an incompatible cable can damage tne device.
- When detaching the USB cable from the device hold the USB connector. Do not pull the wire.
- Do not store, use or charge devices near heat sources and flammable objects, in low or high ambient temperatures.
- Charing can be done only under adult supervision. Recommended temperature is 5 to 35 “C.
- Do not expose the device to strong impacts or mechanical shock. Do not attempt to disassemble, repair or modify the device by yourself. Any device modification results in the termination of the warranty. Contact the service center if the device needs rep repairs
- The device should be protected from high humidity, rain, dust, and dirt. Do not allow water to enter the device, do not put the device in water.
- Prevent exposure of the device to direct sunlight.
- Keep the device out of the reach of children. Do not bite or lick the device, as this may damage or explode it. his device should not be used by young children or persons
- With disabilities without the Supervision of the responsible person providing safe use. Prevent young children from playing with a device.
- Do not insert foreign objects into device ports.
- Use dry soft lint-free cloth to clean the device. It is not allowed to use cleaning liquids.
- The device is not intended for commercial use.
- Do not cover the working device with a cloth or other material.
STORAGE CONDITIONS
Keep the device in a dry, well-ventilated place, far from heaters and direct sunlight. Keep the device out of reach of children.
WARRANTY
The warranty period is 12 months. The warranty does not cover accessories
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>