PHANTEKS PH-GB4090GB Gigabyte Innovative Computer Hardware Design Installation Guide

PHANTEKS PH-GB4090GB Gigabyte Innovative Computer Hardware Design

PACKAGE CONTENTS

WARN I NG – This product is intended for advanced users. Improper installation may result in damage to your equipment. While all efforts have been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.

STEP 1. REMOVING STOCK COOLER

Unscrew all highlighted screws to remove the stock cooler and backplate.

• backplate screws
• stock cooler screws
  Make sure to unplug the LED and Fan cables when you remove the stock cooler.

STEP 2. APPL YING THERMAL PASTE & PADS

Clean off the original thermal compound. We recommend using isopropanol alcohol.
Remove the protective film and place the the thermal pads on the correct position on the PCB.
Apply the Phanteks Thermal Compound to the center of the GPU chip.

STEP 3. MOUNT THE WATER BLOCK

• Secure the support bracket to the GPU block first.
• Carefully position the water block onto the graphics card. Align the mounting holes on the PCB with the holes on the water block.
• Secure the water block with 6 M2.5x5mm screws and washers to the PCB.
• Secure the Support Bracket with the original cooler screw.
  Make sure to lay the GPU with the water block flat down without resting on the PC/ bracket.

STEP 4. APPL YING THERMAL PADS

Remove the protective film on both sides and place the thermal pads on the correct position on the backplate.

STEP 5. INSTALL THE BACKPLATE

Carefully position the backplate onto the graphics card. Align the mounting holes on the PCB with the holes on the backplate.\ Secure the backplate with 6x M2.Sx8mm and 2x M2.Sx6mm flush screws to the PCB.

STEP 6. INSTALL INTO THE SYSTEM

1. Connect the D-RGB cable to the D-RGB strip in the water block.
   All Phanteks 0-RGB products can be !Iii daisy-chained together.

2. Install ther GPU into the system.

3. Install the waterloop and Stop Fittings.
   Always perform a leak test before providing power to any system components.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>