OPT7 LED Side Marker for Jeep Wrangler JL and Gladiator JT 18-22 Installation Guide
- June 8, 2024
- OPT7
Table of Contents
OPT7 LED Side Marker for Jeep Wrangler JL and Gladiator JT 18-22
PRODUCT SPECFICATIONS
Voltage: 12V
Waterproof Rating: IP67
Shell Size: (L)15.35(W)8.86(H)1.11 inch
PACKAGE CONTENT
-
FENDER LIGHT (R) x1
-
FENDER LIGHT (L) x1
-
SCOTCHLOK (T-TAP) x1
-
6.56FT EXTENSION WIRE x1
-
BOOSTER x4
-
DOUBLE-SIDED TAPE x10
-
CABLE HOLDER x10
INSTALLATION
IMPORTANT
Please carefully check the product for any appearance or functional defects
before you start installation
STEP 1
Please thoroughly clean the painted surface around the air vent with isopropyl
alcohol ( rubbing alcohol ) to remove dust or residue that may inhibit tape
bonding as shown in Figure 1.
STEP 2
Use the plastic removal tool to gently pry off the air vent cover and route
the electrical harness of the fender light through the rear channel and into
the engine bay as shown in Figure 2.
STEP 3
Tear off the 3M tape on the back of the fender light.
Then align the side vent cover and press lightly for a few seconds to make
sure it’s firmly in place as shown in Figure 3.
STEP 4
Next, grab the black wire(Ground) and fix it to the side post as shown in
Figure 4.
STEP 5
There are 3 options to manage your fender lights.
-
Run the Red wire to the Driver’s side Footwell
Take out the courtesy light and then use a T-Tap to connect it to the Yellow wire as shown in Figure 5. Once that’s done, you’ll be able to light it by opening the door or using the Keyfob.
-
Run the Red wire to the Reverse light
Then use a T-Tap to connect it to the Reverse signal wire. Once that’s done, you’ll be able to try switching to reverse to light it up. -
Run the Red wire to the AUX Switch/Panel
Then use a T-Tap to connect it to the Ground wire of the switch. Once that‘s done, you’ll be able to turn it on manually if needed. (Note: Auxiliary switch/panel must be purchased separately)
STEP 6
Now, let’s repeat the same steps on the Passenger Side and enjoy it.
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>