rombica BT-H015 Bluetooth Speaker User Manual
- June 9, 2024
- rombica
Table of Contents
rombica BT-H015 Bluetooth Speaker
GENERAL INFORMATION
- BT-H019, BT-H020, BT-H021 models only
- Mic
- AUX
- Micro-USB port
- LED indicator
- Backward/Vol- button
- Short press – decreasing volume
- Long press – playing previous song
- Pause / Play/ Power button
- Short press – play/ pause
- Long press – power on / power off
- Short double press – call back to the last caller (Bluetooth mode)
- Short press during incoming call – receive incoming call (Bluetooth mode)
- Long press during incoming call – reject incoming call (Bluetooth mode)
- Forward/Vol+ button
- Short press – increasing volume
- Long press – playing next song
- ANC button (BT-H019, BT-H020, BT-H021 models only) Short double press – activate/deactivate Active Noise Cancellation
SPECIFICATION
- Power: DC 5V, from battery
- Bluetooth version: v4.1
- Frequency range: 20 Hz – 20 kHz
- Active Noise Cancellation: yes (BT-H019, BT-H020, BT-H021 models only)
- Driver power: 30 mW
- Driver diameter: 40 mm
- Sensitivity: 110 dB 3 dB
- Impedance: 32 Ohm
- Battery: 300 mAh / 3. 7V
- Interfaces: micro-USB, AUX, BT, mic
- In the box: headphones, USB cable, AUX cable, manual
OPERATION OF THE DEVICE
POWER ON
Press and hold Pause / Play/ Power button. Sound notification and turned-on LED indicator will confirm power on
POWER OFF
Press and hold Pause / Play/ Power button. Sound notification and turned-off LED indicator will confirm power off
PARING VIA BLUETOOTH
- Make sure that AUX cable is not connected to the device. Turn on headphones
- Open the Bluetooth setting on your smartphone, enable Bluetooth and search for new devices. When Bluetooth headphones found, confirm pairing
- After successful pairing both the Bluetooth headphones and your device, you can control playback by Bluetooth headphones buttons
PHONE CALLS
You could receive incoming calls with Bluetooth headphones if they paired to the smartphone. You can talk using built-in mic and drivers. Short press Pause / Play/ Power button to receive the incoming call. Press button again to end the call. Long press Pause/ Play/ Power button is rejecting the incoming call. Fast double press Pause/ Play/ Power button to call the last caller.
AUX PLAY
Use (supplied) AUX cable and connect it to the Bluetooth headphones by one side and the external device by another side. Be sure that cable is well connected Bluetooth mode is not available when AUX cable is connected to the device. Playback control by buttons on the headphones is not available when AUX cable is connected to the device
ANC MODE (BT-H019, BT-H020, BT-H021 models only)
- Active Noise Cancellation (ANC) technology reduces noises of your sunroundings. Quick double press on
- ANC button to activate ANC mode, LED indicator turns green if ANC mode is active. Quick double press on
- ANC button again to deactivate ANC mode. Don’t forget to deactivate ANC mode after using headphones
BATTERY CHARGING
Before use, fully charge Bluetooth headphones within 1 O hours. New battery requires 2-3 full charge-discharge cycles to reach full capacity. Use (supplied) cable and connect it to the Bluetooth headphones by micro-USB side. Connect USB cable to the PC or wall charger (wall charger is not supplied). LED indicator is red while charging and become blue when the battery fully charged
STORAGE CONDITIONS
Keep the device in a dry, well-ventilated place, far from heaters and direct sunlight. Keep the device out of reach of children. Do not bite or lick the device, as it may cause damage or explode the device. Children or persons with disabilities should not use the device without supervision of the responsible person
SAFETY INFORMATION
- Before charging be sure that voltage of the power is 5V. The recommended adapter is 5V / 500 mA
- If device is not used during long time, charge it at least once per month
- In case of breaking do not try to open and repair device by yourself. Use service center
- Avoid influence of the high humidity, dust and dirt. Use dry soft lint-free cloth to clean device. Not allowed to use washing or cleaning liquids.
- Do not store, use or charge device near heat sources and flammable objects, during low or high ambient temperatures. Charing can be done only under adult supervision. Recommended temperature is 5 to 35 .c
- Not allowed to drop or hit device.
- Do not insert foreign objects to the device interfaces
- Turn off device after use
- Never pull the cord to disconnect cable, pull the plug
- Bluetooth headphones is not intended for the commercial use
- Standard battery life is 500 charge-discharge cycles. After exceeding 500 cycles the effective capacity of the battery can be reduced. Effective capacity also depends on the ambient temperature.
- Do not cover working device by cloth or other material
TECHNICAL CHARACTERISTICS AND APPEARANCE MAY BE CHANGED WITHOUT PRIOR NOTICE
Do not dispose with household waste! Required to dispose this electrical device at a designated recycling collection point for electrical devices. It ensures that device is recycled professionally and prevents the release of harmful substance into the environment. Make sure that device is uncharged before disposal.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>