KUZCO CH95942 LED Chandelier Instruction Manual

June 9, 2024
KUZCO

KUZCO CH95942 LED Chandelier

START FROM HERE

  • Make sure POWER is COMPLETELY OFF at the fuse box
  • Have your fixture installed by a qualified licensed electrician
  • Prepare everything in a clear area
  • Wear gloves at all times during this installation
  • Read instructions carefully before you start assembly
  • Keep this installation sheet for future reference

Please Note:

  • This Kuzco LED fixture comes with pre-wired LED module(s)
  • Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
  • For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required

Technical Support: 1-855-855-8926

  1. Remove the fixture from it’s original packaging

  2. Separate the mounting plate (1c) from within the canopy (2a) by removing the canopy screws (2b)

  3. Attach mounting plate (1c) to electrical junction box (1a) using screws provided (1e) in hardware package

  4. To change fixture height, push and hold wire gripper (2g), slide wire to desired length and then release wire gripper (2b) to secure

  5. Secure mounting plate (1c) to mounting surface with anchors (1f) and screws (1g)

  6. Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package

  7. Secure canopy (2a) to mounting plate (1c) with canopy screws (2b)

  8. Fine tone wire length if necessary, by push and hold wire gripper (2g) and then adjust wire to desired length

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W: kuzcolighting.com
20220322

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals