SoClean Adapter for ResMed S9 Instructions

So Clean Adapter for ResMed S9

CONNECTING TO:

So Clean Adapter for ResMed S9

1. Detach the Injection Fitting from the Injection Hose A. You will no longer need the Injection Fitting and Injection Hose B. Save these parts in case you  need them in the future.
   

2. Remove the original lid from your humidifier by opening the lid fully, grasping it near the hinges and pushing firmly away from the unit.
   

3. Remove the silicone gasket  from the original lid and install  it onto the new lid, making sure the gasket lies flat and fits over the two tabs. Install the new lid with the black adapter hose by lining up the hinges and pulling firmly toward you until you hear a clicking in both hinges.
   

4. Add water to your reservoir, if needed. When closing the new lid, make sure that the hose on the underside passes into the reservoir opening and rests near the bottom.
   

5. Connect the Injection Hose A by pushing it onto the end of the port of the adapter lid.
   

6. To achieve the proper seal, firmly push down on the lid top until you hear a click. You are now ready to use the So Clean.
   

| WARNING: Injection Hose A must be attached to the So Clean adapter at all times when operating your PAP or the So Clean.
---|---

DISCONNECTING THE:

So Clean Adapter for ResMed S9

1. Remove the Injection Hose A that is connected to the stem of the adapter by firmly pulling it off.
   

2. Open the adapter lid fully.
   

3. Remove the adapter lid by grasping it near the hinges and pushing firmly away from the unit.
   

4. Remove the silicone gasket from the adapter lid and install it onto your original reservoir lid making sure the gasket lies flat and fits over the two tabs.
   

5. Install your original reservoir lid by lining up the hinges and pulling firmly toward you until you hear a clicking  in both hinges.
   

6. Close your reservoir lid.
   

IMPORTANT: If you need to disconnect the So Clean from your adapter, please reinstall the original humidifier lid onto your PAP machine. If you fail to do this, the water in your humidifier will be pushed out through the hose and flooding will result. So Clean is not responsible for damage resulting from equipment mishandling.

If you need help connecting your adapter, contact So Clean.

EU 00800 5558 8811

soclean.com | [email protected]

12 Vose Farm Road | Peterborough, New Hampshire 03458 USA

Documents / Resources

| SoClean Adapter for ResMed S9 [pdf] Instructions
Adapter for ResMed S9, ResMed S9, S9
---|---

References

• SoClean | Bettering Lives Through the Power of A Better Clean

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>