cudy MF4 Mobile Wi-Fi Router Installation Guide
- June 9, 2024
- cudy
Table of Contents
MF4 Mobile Wi-Fi Router
Installation Guide
Install the SIM Card and Battery
Connect to the Internet
a. Press and hold the Power button to power on the Mobile Wi-Fi. 
b. Connect your wireless device to the Mobile Wi-Fi using the SSID and the Wireless Password you have noted down.
Note:
If you cannot access the internet, refer to FAQ > Q1.
- By default, Power Saving is enabled and the Mobile Wi-Fi will turn off Wi-Fi when no wireless devices are connected to it for 5 minutes.
- To resume the Wi-Fi connection, press the Power button.
Enjoy the internet!
Customize the 4G LTE Router
-
Make sure your computer is connected to the router.
-
Launch a web browser, and enter http://192.168.10.1/ in the address bar. Use admin for account and password to log in.
-
Follow the step-by-step instructions of the Wizard to complete the initial configuration.
Button and Interface
| 1. WPS Button | 4. Nano SIM Card Slot |
|---|---|
| 2. Power Button | 5. Reset Button |
| 3. USB Port |
LED Indicators
| LED | Status | Explanation |
|---|---|---|
| **** | Blue Solid | Registered to LTE/3G |
| Off | No Service/No SIM | |
| **** | Blue Solid | Wi-Fi is enabled |
| Blue Flash | WPS is activated | |
| Off | Wi-Fi is disabled | |
| Blue Solid | Device powered on | |
| Blue Blink Slowly | Charging | |
| Blue Flash | Battery is low (<10%) | |
| Off | Device Powered off |
Note:
Blink Slowly: Turn on-1s,Turn off-1s
Flash: Turn on-0.2s,Turn off-0.1s
Frequently Asked Questions
Q1. What should I do if I cannot access the internet ?
A. Visit the web management page (http://192.168.10.1) on your phone, enter
admin to log in, then check the following:
Check PIN status
If the current SIM card status is PIN Locked, your SIM card is PIN protected
and you need to unlock it using the PIN code provided by your mobile carrier.
Go to WAN > PIN to verify if PIN is required. If it is, enter the correct PIN
provided by your ISP, and click Apply.
Verify the mobile carrier parameters
Go to WAN > APN settings to verify the parameters provided by your ISP are
correctly entered. If the parameters are incorrect, select Add New and enter
the correct parameters, then select the new profile from the Profile list.
Check the Data Roaming settings
If your SIM card is operated in a roaming service area, go to WAN >
Connections to enable Data Roaming.
Check Data Limit
Contact your mobile carrier to check whether your data usage has exceeded the
Total/Monthly allowance.
Q2. How do I restore the Mobile Wi-Fi to its factory default settings?
A. With the Mobile Wi-Fi powered on, remove the cover, then use a pin to press
and hold the Reset button for 5s before release.
Note: Restoring the device to its factory defaults will clear all your
settings.
Declaration of Conformity
Cudy hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/53/EU,
2009/125/EC and 2011/65/EU,Directive (EU)2015/863.
The original EU declaration of conformity may be found at
http://www.cudy.com/ce.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>