Ningbo Cstar Imp Exp 0118 True Wireless Earbuds Case User Manual
- June 9, 2024
- Ningbo Cstar Imp Exp
Table of Contents
Ningbo Cstar Imp Exp 0118 True Wireless Ear
GETTING STARTED
- Micro USB charging port
- Charging Case LED indicators
- Left earbud LED indicator
- Left control touch button
- Right earbud LED indicator
- Right control touch button
LeftEarbud/Right Earbud
Pause/Play/Answer Call/End Call
CHARGING YOUR CASE
- Charging the charging case: It will request 1-2 hours to complete the charging. The charging case LED indicator will flash blue and turn into solid blue after fully charged
- Do not charge longer than suggested time. Do not charge overnight.
CHARGING YOUR EARBUDS
- Please remove the insulating trip before charging earbuds
- Place Right and Left Earbuds in charging case
- Charging case LED indicator (2) will illuminate Blue and the earbud LED indicators (3,5) w ill illuminate Red, indicating that the earbuds are charging properly. When Earbuds LEDs (3,5) turns off, earbud batteries are fully charged.
MONO MODE (SINGLE EARBUD USE)
- Remove the earbud from charging case
- Once the earbud is powered on, It will automatically proceed to pair
STEREO MODE (DUAL EARBUD USE)
- Remove both earbuds from the charging case and close each other
- Earbuds will automatically link together after a few seconds, and earbuds will have a tone One earbuds will flash red and blue, and another earbuds will flash blue only.
- Once Earbuds are linked together you may proceed to pair with your mobile device.
PAIRING
- Search for the pairing name “CPP-6329” and select it on your mobile phone Once the earbuds are successfully paired, a notification will sound.
- Now you can enjoy your wireless Earbuds.
Note: 1. Once earbuds have been initially paired successfully with your mobile device, they will automatically pair the next time.
- Model: CT04042
- Item No.: CPP-6329
- Capacity(Cradle): 300mAh / 3.7V (1.11Wh)
- Capacity(Earbuds): 30mAh /3.7V (0.111Wh)
- Input of earbuds: 5V / 60mA
- Input of Cradle: 5V / 300mA (micro USB)
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>