cudy LT300 300 Mbps Wireless N 4G LTE Router Installation Guide
- June 9, 2024
- cudy
Table of Contents
cudy LT300 300 Mbps Wireless N 4G LTE Router
Quick Installation Guide
-
Insert the Micro SIM card into the slot until you hear a click.
SIM card requirement
- Size: Use a micro SIM card, or manually convert a nano SIM card using the SIM card adapter.
- Direction: With the gold contacts facing down, gently slide the SIM card into the slot.
- Note : To prevent damage, do not insert a nano SIM card directly, and do not insert an empty SIM card adapter or any other object into the slot.
-
Connect the LAN port of the router to the PoE port of the PoE adapter via an Ethernet cable.
-
Plug the PoE adapter into a power outlet.
-
Check the LED status, as long as one bar of signal strength turns solid, your router is successfully connected to the Internet. This process may take 2~5 minutes.
- Connect to router via ethernet cable or WiFi.
Wired
Connect your computer to the PoE Adapter’s LAN ports via Ethernet cable.
Wi-Fi
Connect to router’s WiFi network, WiFi network name and password, listed as below:
-
WiFi Network Name: Cudy-LT300-Outdoor
-
WiFi Password: password
-
Launch a web browser and enter http://cudy.net/ (or http://192.168.10.1/) in the address bar, use admin as password to login.
-
Below page would pop up if your SIM card needs PIN to unlock. Please enter your PIN and click “Save & Apply”, then wait 15 seconds to connect to the Internet.
-
Then please check 4G information card of the status page. If the status is connected, means connected to the internet successful-ly.
-
If 4G is not connected, or if you want to customize the router yourself, click “Quick Setup” and follow the step-by-step instructions to customize the 4G, WiFi or other parameters.
Note:
- If you are not sure about APN parameters, please contact your internet provider.
- If you meet any other problems, don’t hesitate to contact our technical support team: [email protected]
Enjoy the internet!
LED and Button
Need Help?
-
Q1. What should I do if I cannot access the web management page?
A1: If the computer is set to a static IP address, change its settings to obtain an IP address automatically.
A2: Make sure http://cudy.net/ or http://192.168.10.1/ is correctly entered in the web browser.
A3: Use another web browser and try again.
A4: Reboot your router and try again.
A5: Disable and enable the active network adapter in use. -
Q2. How do I restore the router to its factory default settings?
A1: With the router powered on, press and hold the RESET button for 5 seconds before release. Wait the router resets.
A2: Log in to the web management page of the router, and go to Advanced Settings >Reset , click Perform Reset and wait until the reset process is complete.
Email : [email protected]
Website:www.cudy.com