GE Lighting 76831LO StayBright LED Taper Candles User Manual
- June 9, 2024
- GE Lighting
Table of Contents
GE Lighting 76831LO StayBright LED Taper Candles
USE AND CARE INSTRUCTIONS
The instructions below should be followed for proper use and care of this product：
- Do not expose candle to moisture.
- Not for outdoor use.
- Replace only with(2) A A batteries.
- Replace all batteries of a set at the same time.
- Clean the battery contacts and also those of the device prior to battery installation.
- Install(2) A A batteries as shown(FIG.2) .
- Remove batteries from product when not in use for an extended period of time.
- Remove used batteries promptly.
- Turn light ON/OFF as shown(FIG.1) .
WARNING: DO NOT expose batteries to fire, attempt to recharge, use
different sizes or install backwards. Do not insert incorrectly. DO NOT mix
old and new batteries. Exhausted batteries are to be removed from the product.
DO NOT mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries. The battery cannot be ingested. Never handle damaged or leaking
batteries – may result in burn injuries or cause serious internal injuries if
swallowed. Obtain medical attention immediately. Misuse can cause battery to
overheat, rupture, leak or explode, resulting in
personal injury and property damage. Do not use rechargeable batteries. Remove
batteries when not used for an extended period of time, or when depleted. KEEP
AWAY FROM CHILDREN
Troubleshooting
| PROBLEM | POSSIBLE CAUSE | CORRECTIVE ACTION |
|---|---|---|
| If the product does not light | 1. The product is not turned on |
2. Battery assembled incorrectly
3. Low power or dead battery
| 1. Turn the switch on the bottom to ON
2. Follow battery installation procedure
3. Replace with new battery
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions：
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- odifications not approved by the party responsible for compliance could void user’s authority to operate the equipment.
Warning： Do not modify this product in anyway unless approved by the manufacturer.
Note： This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates， uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures：
- Adjust or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Questions,call customer service toll-free at
1-877-398-7337 or visti us on the web
at www.geholidaylighting.com
Nicolas Holiday Ltd. 246 Spring Hill Road, Unit B, Trumbull CT 06611
@2022 Nicolas Holiday Limited,9F.,No. 37, Guangfu N. Rd Taipei, Taiwan 10560.
All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>