fantastic Cobra TWS Gaming Headset User Manual
- June 5, 2024
- fantastic
Table of Contents
fantastic Cobra TWS Gaming Headset
Thank you for choosing this Fontastic® TWS Headset „Cobra“. Besides the music mode, the headset offers a gaming mode with 3D sound and low latency for gaming or TV without audible delay. The headset is also perfectly suitable for hands-free phone calls.
Package contents
- 2 x Cobra wireless headset
- Storage and charging case
- USB Type-C™ charging cable
- 2 pairs of ear tips
- User manual
Overview:
- Status LED
- Multifunction sensor
- Earpiece
- Speaker
- Charging contacts
- Case cover
- Headset slot
- Charging contacts
- Headset charging status
- Charging status of case
- Type-C™ charging port (on the rear)
Inserting headsets
Carefully insert the headsets into your ears, setting an appropriate angle for
a comfortable fit. Choose the size of earpiece that you feel most comfortable
with.
Getting Started
Charging the headsets
Insert the headsets into the charging case slots. Close the charging case. By
closing the charging case, the headsets get contact and are automatically
charged in the case. The status LEDs of the headsets light up permanently red
during charging process and go off when fully charged. The charging status of
the left and right headset is indicated via the LED display in the charging
case (9).
Charging the case
Connect the charging cable that came with the case to the Type-C™ charging
input of the case and a travel charger or USB port of a computer to charge the
built-in battery. The inserted headset units and the charging case are charged
simultaneously.
The charge status indicator flashes while charging and lights up solid when
fully charged.
Attention: Fully charge the charging case and the headsets before first
use.
Switching On/Off
- Automatic power on: The headsets turn on automatically when the charging case cover is opened. Manual power on: Press the multifunction sensor for 3 seconds when the headset is off.
- Automatic power-off: Place the headset units back into the charging case and close the charging case cover. Manual power off: Press and hold the multifunction sensor for 5 seconds.
Note: Both headsets turn on and off automatically when removed from the case or inserted.
Pairing
The Cobra headset must be paired with a Bluetooth® enabled device to be used.
- By opening the case cover, the headsets automatically turn on, sync with each other, and enter pairing mode to connect to a Bluetooth® source.
- Search for „Cobra“ on your Bluetooth® enabled device and select it from the list of found devices to pair the headset with the Bluetooth device.
Note: When the headset is placed in the charging case, the connection is interrupted. As soon as both headsets are removed, they will automatically reconnect. If the headset units do not connect auto-matically or an existing connection is disconnected, switch both headsets off and on again either by inserting and removing them from the charging case, or manually. If the headset does not find a Bluetooth®-ena-bled device, it switches off after approx. 3 minutes.
Control
All control commands for music control, phone function and mode settings are executed by tapping the multi-function sensors of the headsets.
- Play music: Single tap on the right or left headset.
- Stop music: Single tap on the right or left headset.
- Next title: Double-tap on the right headset.
- Previous track: Double-tap on the left headset.
- Answer or end call: Single tap on the right or left headset.
- Reject incoming call: Touch and hold right or left headset for 2 seconds.
- Redial: Tap the right or left headset four times.
- Change mode: Touch and hold right or left headset for 3 seconds.
- Activate voice assistant: Three taps on the right or left headset.
Adjusting the volume
The volume is adjusted via the Bluetooth source.
Note: In rare cases, the super bass of the headset may be overdriven by
the settings of the mobile phone. In this case, use the „Normalise“ function
(also „Adjust volume“) in the audio settings of your phone.
Safety advice:
- Do not use the headset at high volume for prolonged periods of time.
- Be careful not to use headset in potentially dangerous situations.
- Do not use the headset while operating a vehicle.
- Never open the device.
- Never immerse the device in water, always protect it from moisture.
- Disconnect electronic devices from the power when not using them for longer time.
- Do not use headphones if they show any visible damage.
Technical data:
Headsets
- BT version 5.1
- Profiles: HFP/ A2DP/ AVRCP/ AVDTP
- Range: up to 10 m
- Driver: 10 mm
- Frequency: 20Hz-20KHz
- Sensitivity: 96 ± 3dB
- Latency: 50-60ms
- Built-in microphone
- Status LED
- Battery: 30 mAh
- Operating time: up to 5 hrs
- Dimensions per unit: 50.3 x 60.4 x 30.5 mm
- Weight per unit: 3g
Charging case:
- Battery: 300mAh (Charges headsets up to 4 times).
- LED charge indicator
- RGB LED effect lighting
- USB Type-C charging port
- Dimensions: 62 x 31 x 50 mm (WxHxD)
The company is not responsible for any damage due to improper operation. If you need technical support, please contact our support team by e-mail at service@fontastic.eu. We hereby declare, that this device carries the CE mark in accordance with the regulations and standards. It conforms with the fundamental requirements of the (RED) 2014/53/EU directive. The full text of the EU Declaration of Conformity is available at the following Internet address www.d-parts.de/Konfo
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU in the national legal system, the following applies: Electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details of this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices, you are making an important contribution to protecting our environment.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks is under license. USB Type-C™ and USB-C™ are trademarks of USB Implementers Forum. Improvements and changes of the technical specifications and other data’s could be made without prior notice. Registered trademarks are the property of their respective owners. Fantastic, by D-Parts GmbH Birkenweiher Str. 16 ● 63505 Langenselbold, Germany www.d-parts.de