GMLighting 12V 3W SDP High Power Dimmable Puck Instruction Manual
- June 2, 2024
- GMLighting
Table of Contents
GMLighting 12V 3W SDP High Power Dimmable Puck
BEFORE YOU START
- Please check local Electrical codes before beginning
- Turn the power off before installing
- Make sure to use properly rated wire
NOTE:
WE RECOMMEND THAT YOU ENGAGE A QUALIFIED AND LICENSED ELECTRICIAN. OPERATING
TEMP.: -4° TO 122°F (-20° TO +50°C). DO NOT INSTALL WHERE THE FIXTURE MAY BE
EXPOSED TO DAMPNESS OR INCLEMENT WEATHER. DRY LOCATION INSTALLATION ONLY.
CONSULT DIAGRAMS AND TURN OFF POWER BEFORE INSTALLATION
DETERMINE LOCATION
Pucks should be located in areas that take advantage of 120° beam spread.
Allow ample room for wiring and mount in close proximity to a 12VDC Class 2
power supply. 5-year warranty is active only when used with a GM Lighting
LineDRIVE Power Supply.
RECESSED MOUNTING
DRILL A 2-1/2” HOLE. Remove the puck light from the surface mounting ring. Push puck light up into hole making sure that springs capture recessed hole. This will insure a good tight fit. (Fig. 1).
SURFACE MOUNTING
INSTALL SURFACE MOUNTING RING by first drilling a small hole to push wires up above the surface (for hiding wires), or if wires are running on the surface, run them through the slot on the surface mount ring. With the 2 screws supplied in the desired location make sure that wires are routed through the notch cut in the surface mounting ring. Push the recessed puck light up into the surface mounting ring, enabline springs to secure a tight fit (Fig. 2).
WIRING
CONSULT WIRING DIAGRAM for wiring instructions: Connect the fixture lead with the white stripe to the positive leads on the 12VDC power supply. Connect the fixture lead without the white stripe to the negative leads on the power supply (Fig. 3).
Use LineDRIVE electronic or magnetic power supplies with 12 VDC output.
NOTE:
DO NOT INSTALL IN AN ENVIRONMENT THAT IS OUTSIDE THE LISTED AMBIENT
TEMPERATURE FOR THIS FIXTURE, AND IN AN AREA THAT IS NOT EASILY ACCESSIBLE FOR
SERVICE REQUIREMENTS.
©2022 GM Lighting
Specifications are subject to change without notice.
18700 Ridgeland Ave.,
Tinley Park, IL 60477
Toll-Free: 866-671-0811
FAX: 708-478-2640
www.gmlighting.net.
tech@gmlighting.net.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>