luminii KBX-X-X-DW Kurba Medium Horizontal Dynamic White Instruction Manual
- June 4, 2024
- luminii
Table of Contents
Kuba Medium Horizontal Dynamic White
Instruction Manual
Models KBX-X-X-DW
Please read all instructions prior to installation and keep for future reference!
*LUMINII RESERVES THE RIGHT TO CHANGE SPECIFICATIONS & INSTRUCTIONS WITHOUT NOTICE
- PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- USE ONLY WITH CLASS 2 POWER UNIT
- 24 VOLTS DC
- SUITABLE FOR WET LOCATIONS
- SURFACE MOUNT ONLY
CAUTION: Reference the diagram below on Can and Can-not, when it comes to installing the Kuba Horizontal & Vertical!
Kurba Horizontal (KBM-XX)
CAN
Bend LED in these positions to avoid damage
CAN NOT
Twisting or bending LED in these positions will cause damage to the LED
CAN
Bend LED in these positions to avoid damage
CAN NOT
Twisting or bending LED in these positions will cause damage to the LED
NOTE: Prior to installation all 24VDC wires must be present within 72” of
the installation. Refer to the power supply installation instruction for
additional information.
NOTE: More than one person is recommended for this installation.
1.1 Once the location or pattern is determined for Kurba to be installed,
start off by marking the area. The number of brackets may vary depending on
the pattern. Reference
diagrams below.
Straight run with mounting channel
A.1
Line up the spring clips to the mounting holes, followed by placing the
mounting channel to the surface. Make sure it’s straight by using a level.
A.2 Secure the channel to the surface by tightening all the provided screws.
If mounting to something other than wood, we recommend using the proper
hardware.
Curved run with mounting channel
B.1 Determine the shape of the Kuba layout, then mark the pattern
on the surface. Then, place a mounting bracket every 8”(minimum).
The pattern may vary depending on the number of curves.
B.2 Secure the mounting brackets to the surface by tightening the screw. If
mounting to something other than wood, we recommend using the proper hardware.
2.1 Carefully push the Kurba onto the channel or mounting brackets, then press in completely to secure in place.
Wiring Diagrams
Using DMX LED power supply
Using a non-dimming LED power supply, receiver, and controller
Operations to Controller
- Press the learning key on the receiver, then push the rotary button. Once successfully learn, the LED lights will blink on the receiver. Do the same for the other receivers if you use them, you can add as many optional receivers as you want.
- Short press the rotary button to switch it on/off. Adjust dim brightness by the rotary button from left to right 0.1 – 100%. Adjust dim brightness by the rotary button from right to left 0.1 – 100%. Long press the rotary button, and the light will be 100% brightness
DDW-MC
Wireless Controller
Double click the rotary button,
and it will enter into dimming color temperature mode, and dim WW & CW
associatively, for example, if WW is 70%, CW is 30%. Double-click again, will
enter into dimming brightness mode.
Using a warm dim LED power supply
Using tunable white LED power supply
Using a non-dimming LED power supply, decoder, and controller
Using a non-dimming LED power supply and decoder
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
REV0.4
07272022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>