IMETAPLUS F2 LED Tailgate Light Bar Instruction Manual

IMETAPLUS F2 LED Tailgate Light Bar Instruction Manual

WHAT’S INCLUDED

INSTALLATION

Note: Lighting laws vary depending on the jurisdiction, check your local laws before installation

STEP 1 Prior to installation, be sure to test the tailgate light bar by temporarily connecting the 4-pin flat connector to the trailer tow hardness to ensure full functionality.

For trucks do not have a 4-pin trailer tow harness, you will have to hardwire the light bar into the truck’s existing wiring and test the running, brake and turn signals for full functionality. See test steps as below:

• First, strip the wire of the tail light assembly or the 7 pin tow harness.
• Activate a function (running, turn signal, brake, or reverse)
• Use a voltmeter to read which wire is showing 12-14V
• Repeat with the each wire till all wires have been identified, mark down each wire if necessary.
  

STEP 2
Remove tailgate from vehicle.

STEP 3
Thoroughly clean the area where the tailgate light bar will be mounted.

STEP 4
Mark out where you want to mount the included clips, taking straightness and placement into consideration.

STEP 5
On the back of the tailgate light bar, peel off the adhesive tape and apply firmly to the cleaned area.

STEP 5
Use the included screws and clips to solidly mount the light bar to the cleaned area.

STEP 6
Splice the white wire coming from the tailgate light bar to the factory tail light or the 7-pin trailer tow hardness,

STEP 7
Turn on the factory lights one by one to check all functions work properly, then reinstall the tailgate.

DISCLAIMER

The Installation Manual is intended as assistance to reduce setup time and not liable for improper installation. If you are uncertain of wiring or inexperienced with aftermarket upgrades, please seek professional assistance.

2 YEAR WARRANTY

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>