RASTAR Ferrari SF1000 2.4GHz User Manual
- June 5, 2024
- RASTAR
Table of Contents
RASTAR Ferrari SF1000 2.4GHz
Read the
complete instructions and security instructions carefully before using the
model.
Caution! Please fully and carefully read warnings/ safety instructions.
These are for our own security and can avoid accidents/injuries.
Suitable for children over 8 years!
Warning:
- Not suitable for children under 36 months. RISK OF SUFFOCATION! Contains small parts which can be swallowed. Keep away necessarily from children.
- This device is not intended for use by individuals (Including children) with reduced physical sensory, mental abilities, lack of experience and/or knowledge unless they are supervised in how the device is to be used.
Certificate of Conformity
Hereby JAMARA e.K. declares that the product „Ferrari SF 1000, No. 403007“
complies with Directive 2014/53/EU, 2011/65/EU and 2009/48/EC. The full text
of the EU Declaration of Conformity is available at the following Internet
address: www.jamara-shop.com/Conformity
Attention!
Never operate your model beyond sight. Both the maximum visibility as well as
the max. range of your model will depend on many factors such as weather,
location and interfering frequencies. Therefore, before each use perform a
range test with a second person securely holding the model and also check how
the model reacts if there is a signal failure e.g. when empty transmitter
batteries are installed.
Tools (not included)
Assembly of components
Installed procedures
Take all parts out an make sure nothing is missing. Do NOT remove all the
parts at first, but just do assembly step by step according to instruction of
the manual. Take the stickers out and stick them on components first according
to the instructions. Assemble the car according to the figure. 
ASSEMBLING
Transmitter
- Forward / Backward
- Left / Right
- Battery compartment
CAR
- A. Trim Lever
- B. On/Off Switch
- C. Battery compartment
Insert the batteries
Remove the battery compartment cover. Fit the 2 / 3 x AA batteries, observe
the correct polarity. Replace the battery hatch
Binding process
Turn on the model. The light on the model flashes. Insert 2 AA batteries into
the transmitter, the LED on the transmitter will flash. When the LEDs on both
the model and the transmitter stop flashing, they are bound.
Battery warning:
- Non-rechargeable batteries are not to be recharged!
- Do not open! Do not dispose of in fire! Do not mix old and new batteries!
- Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!
- Rechargeable batteries are to be removed from the toy before being charged!
- Rechargeable batteries are only to be charged under adult supervision!
- The supply terminals are not to be short-circuited!
Attention!
Let the model cool off sufficiently after each use before putting it back into
operation. Let the model cool off sufficiently after each use before putting
it back into operation. When changing batteries there has to be a cooling
phase of at least 10 min before model can be operated again. Overheating can
damage the electronics or may result in fire.
Keep hands away from moving parts.
Use only under direct supervision of an adult!
The batteries are nearly, replace the batteries. Pay attention to the
polarity!
Pay attention to the frequencies in your environment!
Do not drive in rain, snow, wetness or sand.
Never drive on roads or areas used by real vehicles. Never run out of the
reach of your remote control. Do not leave in very strong sunlight. Clean by
using a damp cloth. Store batteries/battery packs
Disposal restrictions
Batteries and accumulators must not be disposed of in domestic waste. You are obliged to dispose of batteries (seperate collection) appropriately. After use you can return batteries free of charge to the retail store. As batteries contain substances that can be irritant, can cause allergy and are highly reactive, separate collections and proper recycling is important to the environment and to your health. If the batteries are marked with a chemical symbol Hg, Cd or Pb below the crossed-out waste bin on wheels it refers to that more than 0.0005% of mercury (Hg), more than 0.002% of cadmium (Cd) or more than 0.004% Lead (Pb) is included.
Frequency bands: 2400MHz to 2483.5MHz
Maximum Transmitting Power (EIRP) : Not more than 10mW.
Applicable age 8 years (96 months) and above.
All rights reserved. Copyright JAMARA e.K. 2022 ● Images belong to Rastar
Copying or reproduction in whole or part, only with the expressed permission
of JAMARA e.K.
Produced under license of Ferrari S.p.A. The name FERRARI, the PRANCING HORSE device, all associated logos and distinctive designs are property of Ferrari S.p.A. The body designs of the Ferrari cars are protected as Ferrari S.p.A. property under design, trademark and trade dress regulations.
Licensee: RASTAR (HK) INDUSTRIAL COMPANY LIMITED Manufacturer:RASTAR GROUP
Add:Xinghui Industrial Park, Xiadao Road, Shanghua, Chenghai, Shantou,
Guangdong, China.
Http://www.rastar.com
Imported by: JAMARA e.K.
Inh. Manuel Natterer
Add.: Am Lauerbühl 5 – DE-88317 Aichstetten
Tel. +49 (0) 75 65/94 12-0 – Fax +49 (0) 75 65/94 12-23
info@jamara.com –
www.jamara.com
Service – Tel. +49 (0) 75 65/94 12-777
service@jamara.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>