Electrolux KFIA19R Extractor Hood User Manual

**Electrolux KFIA19R Extractor Hood

**

WE’RE THINKING OF YOU!

Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Welcome to Electrolux.

Visit our website to:

 Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support

 Register your product for better service: www.registerelectrolux.com

 Buy Accessories, Consumables and Original spare parts for your appliance: www.electrolux.com/shop

CUSTOMER CARE AND SERVICE

Always use original spare parts. When contacting our Authorised Service Centre, ensure that you have the following data available: Model, PNC, Serial Number. The information can be found on the rating plate.

 Warning / Caution-Safety information
 General information and tips
 Environmental information

Subject to change without notice.

SAFETY INFORMATION AND INSTALLATION

WARNING!
Refer to the separate Installation Instructions booklet for Safety Information and Installation. Read carefully the Safety chapters before any use or maintenance of the appliance.

PRODUCT DESCRIPTION

Control panel overview

off the appliance.
Second speed| The motor switches to second speed level.
Third speed| The motor switches to third speed level.
Maximum speed| The motor switches to maximum speed level. After 5 minutes appliance switches to third speed.
Filter notification| Reminds to change or clean the charcoal filter and clean the grease filter
Hob²Hood| Indicator of the function to control hood from hob. For some models the symbol present on the control panel.

DAILY USE

Using the hood

Check the recommended speed according to the table below.

| While heating up food, cooking with covered pots
---|---
| While cooking with covered pots on multiple cooking zones or burners, gentle frying.
| While boiling and frying big quantities of food without a lid, cooking on multiple cooking zones or burners.
| While boiling and frying big quantities of food without a lid, big humidity.

It is recommended to leave the hood operating for approximately 15 minutes after cooking.

To operate the hood:

1. Press the first speed button to switch on the appliance.
2. If needed, change the speed by pressing the desired button.

 The hoods light works independently to other hood functions. To illuminate the cooking surface press the light button.

To turn off the appliance press the first speed button again.

Hob²Hood function

It is an automatic function which connects the hob with a hood. Both the hob and the hood have an infrared signal communicator. Speed of the fan is defined automatically on basis of mode setting and temperature of the hottest cookware on the hob. You can also operate the fan using the hob manually. The function can be activated from panel of the hob.

For more information how to use the function refer to the hob user manual.

Filter notification

Filter alarm reminds to change or clean the charcoal filter and clean the grease

CARE AND CLEANING

Notes on cleaning

| Do not use abrasive detergents and brushes. Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
---|---

Cleaning Agents| After cooking some parts of appliance can get hot. To avoid stains appliance must be cooled down and dried with clean cloth or paper towels.
| Clean stains with a mild detergent. To clean glass surfaces, use alcohol- based detergent.

filter. The filter indicator is turned on for 30 seconds if the grease filter must be cleaned. The filter indicator flashes for 30 seconds if the charcoal filter must be replaced or cleaned.

Refer to cleaning the grease filter in care and cleaning chapter.

Refer to cleaning the charcoal filter or replacing the charcoal filter in care and cleaning chapter.

To reset the function press the button for 3 seconds.

To activate or deactivate function:

1. To activate function press the button for 3 seconds. If the function is activated, the indicator  flashes two times.
2. To deactivate function press the button  for 3 seconds. If the function is deactivated, the indicator  flashes ones.

Keep the hood clean| Clean the appliance and grease filters each month. Clean the inte‐ rior and grease filters carefully from fat. Fat accumulation or other residue may cause fire. Follow the instructions for cleaning the accessories when filter notification is on. Refer to Filter notification in daily use chapter.
---|---
Grease filters can be washed in a dishwasher. The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the per‐ romance of the appliance.
Charcoal filter| The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter. The activated charcoal filter is not washable, cannot be regenerated and must be replaced approximately every 4/6 months of operation, or more frequently for particularly heavy usage.
---|---

Cleaning the grease filter

Filters are mounted with the use of clips and pins on the opposite side.

To clean the filter:

1. Press the handle of the mounting clip on the filter panel underneath the hood (1).

2. Slightly tilt the front of the filter downwards (2), then pull. Repeat the first two steps for all filters.

3. Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
   The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance.

4. To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.

Replacing the charcoal filter

WARNING!
The charcoal filter is nonstable!

To replace the filter:

1. Remove the grease filters from the appliance.
   Refer to “Cleaning the grease filter” in this chapter.

2. Remove the clips holding the filter bed, then the filter bed.

3. To install a new filter, perform the same steps in reverse order.

In any case, it is necessary to replace the filters at least every four months.

Replacing the lamp

This appliance is supplied with a LED lamp and separate control gear (LED

ENVIRONMENTAL CONCERNS

Recycle materials with the symbol Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of driver). These parts can be replaced by a technician only. In case of any malfunction refer to “Service” in the “Safety Instructions” chapter.

appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.

References

• Buy Electrolux Spare Parts | Electrolux Australia
• Electrolux
• Register Your Appliance – Product Registration – Electrolux

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>