ATDEC AD-WF-10090 Fixed Wall Mount 10090 Installation Guide
- June 3, 2024
- ATDEC
Table of Contents
Fixed Wall Mount 10090
Installation Guide
AD-WF-10090
COMPONENT CHECKLIST
NOTE:
-
Wall Plate Mounting Fasteners are NOT supplied with Wall Mounts.
Professional installer to ensure correct Mounting Fastener type, location & quantity to suit structure where Wall Mount is installed. -
ALWAYS use a washer between the chosen fastener and the wall plate.
-
Mounting fasteners to be used as per manufacturers instructions, including minimum engagement to achieve necessary performance.
REQUIRED TOOLS
- Phillips head screwdriver
- Power drill
- Suitable drill bit
- Driver bit for selected wall fasteners
- Stud finder
- Spirit level
WEIGHT RANGE
0 – 100kg
(0 – 220lb)
IMPORTANT INFORMATION
- Please ensure this product is installed as per these installation instructions.
- The manufacturer accepts no responsibility for incorrect installation.
- Failure to mount this product correctly may cause serious injury/death during or following installation.
- This product is not suitable for outdoor use.
- Do not use this product for mobile applications.
- Wall Plate only achieves maximum weight rating when appropriately fastened to a wall of adequate structural capacity.
- Professional installer to ensure adequate structural capacity of wall (including appropriate safety factor) to support total weight of all equipment being mounted.
- Drilling into electrical wires can cause death-use appropriate equipment and caution when drilling holes in walls to avoid electrical cables, water pipes and gas pipes. Do not drill into structures unless you have established it’s safe to do so.
-
Mount the Wall Plate to the Wall
NOTE:
**** • Choice and supply of appropriate wall plate fasteners is the responsibility of the installer.
• Consult a preferred fastener supplier or a structural engineer to select fasteners which are most appropriate for the weight of the display and wall construction method.
• Wall plate must be level. Verify using a quality spirit level tool.
• On a Stud Wall or Drywall use a good quality Stud Finder to position mounting fasteners in the centre of studs.
• On a Masonry Wall avoid positioning Wall Plate mounting fasteners in a mortar join. -
Attach the Display Brackets to the Display
NOTE:
• Always use multi-washers M-F.
• Ensure the display brackets are not loose and screws are not forced too deep into the display.
• If spacers are needed, use the shortest possible combination between the display bracket and the display. -
Hook the Display onto the Wall Plate
3.1. Angle the display and hook the Display Brackets over the top of the Wall Plate. This should be completed by two people.
3.2. The silver locking tabs on the Display Brackets will make a “click” sound to confirm a secure installation. You may need to gently apply pressure to the lower half of the display if this does not happen automatically.
NOTE:
Ensure the silver locking tabs are pushed in prior to mounting the display. -
Check Security and Conceal Straps
4.1. Gently pull the display forwards from bottom of the display to ensure the the locking tabs have engaged with the wall plate and the display cannot be tilted upwards.
4.2. Conceal straps behind the display using the magnets at the end of each strap to prevent accidental unlock and dismount of the display.
NOTE: Ensure the silver locking tabs are pushed in prior to mounting the
display.
NOTE: To unlock display from the Wall Plate for display removal-retrieve
the straps from their concealed position and pull each strap down once briefly
until a “click” is heard.
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. ©20220221
Please Recycle
AD-WF-10090 Page 2 of 2
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>