ATDEC AD-WF-5060 Fixed Wall Mount 5060 Installation Guide

ATDEC AD-WF-5060 Fixed Wall Mount 5060

COMPONENT CHECKLIST

NOTE:

• Wall Plate Mounting Fasteners are NOT supplied with Wall Mounts. Professional installer to ensure correct Mounting Fastener type, location & quantity to suit the structure where Wall Mount is installed.
• ALWAYS use a washer between the chosen fastener and the wall plate.
• Mounting fasteners are to be used as per manufacturers’ instructions, including a minimum engagement to achieve the necessary performance.

REQUIRED TOOLS

• Phillips head screwdriver
• Power drill
• Suitable drill bit
• Driver bit for selected wall fasteners
• Stud finder
• Spirit level

WEIGHT RANGE

• 0 – 50kg
• (0 – 110lb)

IMPORTANT INFORMATION

Please ensure this product is installed as per these installation instructions

• The manufacturer accepts no responsibility for incorrect installation.
• Failure to mount this product correctly may cause serious injury/death during or following installation.
• This product is not suitable for outdoor use.
• Do not use this product for mobile applications.
• This product supports a maximum load of 50kg (110lb).
• Wall Plate only achieves maximum weight rating when appropriately fastened to a wall of adequate structural capacity.
• Professional installer to ensure the adequate structural capacity of wall (including appropriate safety factor) to support total weight of all equipment being mounted.
• Drilling into electrical wires can cause death – use appropriate equipment and caution when drilling holes in walls to avoid electrical cables, water pipes and gas pipes. Do not drill into structures unless you have established it’s safe to do so.
• Suits displays with mounting hole patterns from 75mm to 620mm wide by 70mm to 405mm high.

Mount the Wall Plate to the Wall

NOTE:

• The choice and supply of appropriate wall plate fasteners is the responsibility of the installer.
• Consult a preferred fastener supplier or a structural engineer to select fasteners that are most appropriate for the weight of the display and wall construction method.
• The Wallplate must be level. Verify using a quality spirit level tool or the included spirit level G.
• On a Stud Wall or Drywall use a good quality Stud Finder to position mounting fasteners in the center of studs.
• On a Masonry Wall avoid positioning Wall Plate mounting fasteners in a mortar join.

Attach the Display Brackets to the Display

NOTE:

• Always use multi-washers D.
• Use the shortest combination of spacers (if necessary) ensuring the display is not loose and screws are not forced too deep into the display.

Hook the Display onto the Wall Plate

1. Angle the display and hook the Display Brackets over the top of the Wall Plate. This should be completed by two people.
2. The silver locking tabs on the Display Brackets will make a “click” sound to confirm a secure installation. You may need to gently apply pressure to the lower half of the display if this does not happen automatically.

NOTE:
Ensure the silver locking tabs are pushed in prior to mounting the display.

Check Security and Conceal Straps

1. Gently pull the display forwards from the bottom of the display to ensure the locking tabs have engaged with the wall plate and the display cannot be tilted upwards.
2. Conceal straps behind the display using the magnets at the end of each strap to prevent accidental unlocking and dismounting the display.

NOTE:
To unlock the display from the Wall Plate for display removal- retrieve the straps from their concealed position and pull each strap down once briefly until a “click” is heard.

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. ©20210813.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>