ATDEC AWM-BT Mounting Bracket for Monitor Installation Guide
- June 15, 2024
- ATDEC
Table of Contents
Installation Guide AWM-BT
Infinite Mounting Possibilities
COMPONENT CHECKLIST
Desk
REQUIRED TOOLS
- Phillips Head Screwdriver
CAPACITY
Flat Monitor
4.5 – 25kg (10 – 55lb)
Curved Monitor
4.5 – 18kg (10 – 40lb)
Display Size
24” – 55” 300mm (12”) max overall display depth
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation
instructions.
! Each Tilt Bracket supports a maximum weight as per above capacity
specification.
! Avoid applying downward load to corners of display.
! This product is not suitable for outdoor use.
! Do not use this product for mobile applications.
! The manufacturer accepts no responsibility for incorrect installation.
! This product is compatible with Atdec AWM Series products.
! VESA mounted accessories (such as mini PC brackets and mounts), and offset
VESA locations exert additional leverage that can exceed the capacity of the
mount even though the monitor weight may be within the stated range. Please
contactAtdec if you would like further information.
! WARNING! Death or serious injury may occur if a child climbs on or tips
product.
Attach VESA plate to display
1.1 VESA compatibility
NOTE:
Some displays require the use of a VESA adapterbefore attaching the VESA
plate. This VESA adapter may ship in the box with the display. Consult your
display’s installation guide for further information.
Option A Attach VESA plate with M4x10mm screws. Option B For recessed VESA use
10mm spacers and M4x20mm Screws.
Slide bracket onto post and set height
2.1 Tilt bracket must only be attached with display facing the front of the mounting surface unless fixing is Grommet Clamp (AC-GC). 2.2 Line up the inner guide n rear of bracket with rear channel on post. VIEW FROM ABOVE 2.3 Slide inner guide into channel and lower bracket. 2.4 Firmly tighten hand knob at chosen height.
Attach display
3.1 Set VESA plate clips to open position. WARNING: Use two people to install display
3.2 Lift display until VESA plate is above the heightof the bracket.
3.3 With post centered slowly lower display until bar on VESA plate sits in saddle in bracket. 3.4 Set VESA plate clips to closed position.
NOTE:
Display hangs from the bracket like a painting. After clips are closed, if
corners of the screen are pushed downwards, rocking movement is expected.
Set tilt
4.1 Adjust display tilt angle by gripping edges of screen and rolling up ordown to desired position.
OPTIONAL ADJUSTMENT – TILT FRICTION
4mm hex key can be used to reduce tilt friction (for light screen) or increase
tilt friction (for heavy screen). 4.2 Tighten tilt knobs to set.
Fine adjustment
5.1 To correct horizontal angle of display +/- 3°: Turn a single fine
adjustment knob to adjust angle of display. 5.2 To close small gap between
displays +/-6mm (1/4”):
Turn both fine adjustment knobs – alternating sides a few rotations at a time.
Clockwise = Higher
Anti-clockwise = Lower No portion of this document or any artwork contained
herein should be reproduced in any way without the express written consent of
Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20230120
Please recycle
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>