superbrightleds STN-1-UC Under Cabinet LED Flexible Light Strip Kit User Manual
- June 3, 2024
- superbrightleds
Table of Contents
superbrightleds STN-1-UC Under Cabinet LED Flexible Light Strip Kit
Included Parts
- 1 – LED Strip
- 1 – Controller with RF Remote (MCBRF-4A)
- 1 – Power Supply (CPS-24V-36W)
- 1 – CPS Connector (CPS-F2ST)
- 1 – 10 ft Section of 2 Conductor 22 AWG Wire (WP22-2)
- 4 – Wire Nuts (WN-2216)
- 14 – Clamp-On Solderless Connectors (SBL-MA2P-8)
- 2 – Double-Sided Adhesive Foam Pads (3M-FTP)
Safety and Notes
- The product should be installed in accordance with applicable national, state, and local electrical codes.
- To reduce the risk of electric shock, ensure that the main power source is switched off and the power supply is disconnected before performing any installation or wiring procedures.
- The product is for use in dry, indoor locations only.
- Do not connect the strip or controller directly to AC power.
- Do not connect components other than those included to the power supply.
- Ensure the polarity of all connections is correct during installation.
Installation Process
Preinstall Check
Remove the strip from the reel and make connect the power supply and
controller. Briefly turn on the strip using the controller power button to
ensure proper operation of the strip, power supply, controller, and remote.
After a successful test, disconnect the power supply and disconnect the
components.
Layout
Layout strip on the counter below cabinets. Hold strips up under cabinets or
measure to determine the lengths of strip segments needed for installation.
Cut strips to desired lengths ensuring all cuts are made only on marked cut
lines.
Strip Installation
Attach solderless connectors (STN8-2PC) to strip ends by placing the connector
fully over the strip and pushing down cap until it locks in place
.
UL certification only applies to the included strip and power supply
Next, ensure all installation surfaces are clean and dry. Begin to remove the strip’s backing while adhering to the bottom front edge of the cabinets for optimal illumination. Press firmly to secure strips to the surface.
Route wire (WP22-2) for strip-to-strip connections under cabinet seams, windows, and other spaces between cabinets. Cut the wire to length and attach wire ends to solderless connectors by placing the wire fully into the connector and pushing the cap down until it locks in place. Ensure the wires are connected to the correct polarity on the strip.
Controller and Power Connection
Use the double-sided foam adhesive pads (3M-FTP) to mount the controller.
Connect lead wires at the end of the strip run to the controller (MCBRF-4A)
with wire nuts (WN-2216). Connect the opposite end of the controller to the
CPS Connector (CPSF2ST). To bypass the controller, connect the lead wires from
the strip directly to the CPS connector.
Connect the power supply (CPS-24V-36W) to the CPS connector and apply power to check for proper operation.
General Installation Diagram
Note:
Wiring may vary based on cabinet configuration and outlet availability
.
Bridging Cabinet Seams
- Do not install strips over cabinet seams.
- Use interconnect sections to connect strips over seams.
Installation Components
UL certification only applies to the included strip and power supply
Rev Date: V0.2 04/21/2022
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>