superbrightleds LFB-W01 LED Ready Landscape Well Light User Manual
- October 30, 2023
- superbrightleds
Table of Contents
LFB-W01 LED Ready Landscape Well Light
Product Information: LED Ready Landscape Well Light
The LED Ready Landscape Well Light is a product that comes in the LFB-W0x
series manufactured by Super Bright LEDs. The product is designed to provide
outdoor lighting for lawns, gardens, and other landscapes. The product comes
with different caps, including LFB-W01, LFB-W02, LFB-W03, LFB-W04, and
LFB-W06. The product also requires some recommended accessories, including
silicone filled twist-on wire connector, self-fusing silicone tape, 14 gauge
landscape wire, 12 gauge landscape wire, gasket MR16 (GU5.3), LED
bulb, housing, cap, lens, PAR36 LED bulb. The product is easy to install, and
it comes with a user manual that provides step-by-step instructions.
Product Usage Instructions
- Read all instructions carefully before installation.
- Choose the appropriate cap for your product.
- Install the compatible bulb into the housing.
- Lay the fixtures out as they will be installed.
- Run landscape wire from power supply to each light. Wire must be within 3 of mounting stake to allow power connections to be made.
- Use waterproof connectors to connect lights to supply wires as well as wires running to additional lights.
- Dig out an appropriate hole for and install the fixture. Turn on power supply and ensure all fixtures are working. If one or more individual fixtures are not working, check each connection. It is recommended to wrap all connections in electrical or self-fusing tape.
- Bury landscape wire, fixture pigtails, and connectors. A depth of 3 is recommended. Wires and connectors can also be covered by mulch or stone.
Note: LFB-W02 shown, others are similar.
Safety and Notes
-
For use with OUTDOOR, low-voltage landscape lighting systems ONLY.
-
NOT FOR USE with submersible or pool/spa equipment.
-
Do not submerge in water, the product can be damaged.
-
For low voltage use only. Power supply voltage must match installed bulb.
-
LFB-W01, LFB-W02, LFB-W03, and LFB-W04 are designed for MR16 (GU5.3 base) bulbs only. LFB-W06 is designed for PAR36 bulbs only.
Bulb not included. -
The housing for LFB-W06 can be installed two ways—for a flat or slanted top—depending on preference.
Recommended Accessories
Part Number | Description |
---|---|
WWN-2212 | silicone filled twist-on wire connector |
SFT-20 | self fusing silicone tape |
WP14-2DB | 14 gauge landscape wire |
WP12-2DB | 12 gauge landscape wire |
Assembly
Installation Instructions
- Install compatible bulb.
- Lay fixtures out as they will be installed.
- Run landscape wire from power supply to each light. Wire must be within 3” of mounting stake to allow power connections to be made.
- Use waterproof connectors to connect lights to supply wires as well as wires running to additional lights.
- Dig out an appropriate hole for and install the fixture.
- Turn on power supply and ensure all fixtures are working. If one or more individual fixtures are not working, check each connection. It is recommended to wrap all connections in electrical or self-fusing tape.
- Bury landscape wire, fixture pigtails, and connectors. A depth of 3” is recommended. Wires and connectors can also be covered by mulch or stone.
Rev Date: V2 04/21/2022
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com