superbrightleds STN-4-UC Under Cabinet LED Flexible Light Strip Kit User Manual
- June 3, 2024
- superbrightleds
Table of Contents
superbright LEDs STN-4-UC Under Cabinet LED Flexible Light Strip Kit
important: Read all instructions prior to installation.
Included Parts
- LED Strip
- Bluetooth Controller (LF-BL-A2)
- Power Supply (CPS-24V-60W)
- 10 ft Section of 5 Conductor 22 AWG Wire (RGBW-5Wire) 14 – Clamp-On Solderless Connectors (SBL-MA5P-12)
- Double-Sided Adhesive Foam Pads (3M-FTP)
Safety and Notes
- The product should be installed in accordance with applicable national, state, and local electrical codes.
- To reduce the risk of electric shock, ensure that the main power source is switched off and the power supply is disconnected before performing any installation or wiring procedures.
- The product is for use in dry, indoor locations only.
- Do not connect the strip or controller directly to AC power.
- Do not connect components other than those included to the power supply.
- Ensure the polarity of all connections is correct during installation.
Installation Process
Preinstall Check
- Remove the strip from the reel and make tonnes o the power supply and controller.
- The controller will need to be o a smart paired t device.
- Refer to the controller user manual for pairing instructions.
- Briefly turn on the strip using the controller to ensure proper operation of the strip, power supply, and controller.
- After the successful test, disconnect the power supply and disconnect the components.
Layout
Layout strip on the counter below cabinets. Hold strips up under cabinets or
measure to determine the lengths of strip segments needed for installation.
Cut strips to desired lengths ensuring all cuts are made only on marked cut
lines.
Strip Installation
Attach solderless connectors (STN12-5PC) to strip ends by placing the
connector fully over the strip and pushing down cap until it locks in place.
-
UL certification only applies to the included strip and power supply
-
Next, ensure all installation surfaces are clean and dry.
-
Begin to remove the strip’s backing while adhering to the bottom front edge of the cabinets for optimal illumination. Press firmly to secure strips to the surface.
Route wire (RGBW-5Wire) for strip-to-strip connections under cabinet seams, windows, and other spaces between cabinets. Cut the wire to length and attach wire ends to solderless connectors by placing the wire fully into the connector and pushing the cap down until it locks in place. Ensure the wires are connected to the correct polarity on the strip. -
Controller and Power Connection Use the double-sided foam adhesive pads (3M-FTP) to mount the controller. Connect lead wires at the end of the strip run to the controller (LF-BL-A2).
-
Connect the power supply (CPS-24V-60W) to the CPS connector on the controller and apply power to check for proper operation.
General Installation Diagram
Note: Wiring may vary based on cabinet configuration and outlet availability.
- Rev Date: V0.2 04/21/2022
- 4400 Earth City Expy, St. Louis, 63045
- 866-590-3533
- superbrightleds.com
Documents / Resources
|
superbrightleds STN-4-UC Under Cabinet LED Flexible Light Strip
Kit
[pdf] User Manual
STN-4-UC Under Cabinet LED Flexible Light Strip Kit, STN-4-UC, Under Cabinet
LED Flexible Light Strip Kit, Cabinet LED Flexible Light Strip Kit, LED
Flexible Light Strip Kit, Light Strip Kit, Strip Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>