superbrightleds STN-2-UC Under Cabinet LED Flexible Light Strip Kit User Manual
- June 3, 2024
- superbrightleds
Table of Contents
superbrightleds STN-2-UC Under Cabinet LED Flexible Light Strip Kit
Important: Read all instructions prior to installation.
Under Cabinet LED Flexible Light Strip Kit
Included Parts
- 1 – LED Strip
- 1 – Controller with RF Remote (MCSH2-1CH-72W)
- 1 – Power Supply (CPS-24V-36W)
- 1 – CPS Connector (CPS-F2ST)
- 1 – 10 ft Section of 2 Conductor 22 AWG Wire (WP22-2) 4 – Wire Nuts (WN-2216)
- 14 – Clamp-On Solderless Connectors (SBL-MA2P-8) 2 – Double-Sided Adhesive Foam Pads (3M-FTP)
Safety and Notes
- Product should be installed in accordance with applicable national, state, and local electrical codes.
- To reduce the risk of electric shock, ensure that the main power source is switched off and the power supply is disconnected before performing any installation or wiring procedures.
- Product is for use in dry, indoor locations only.
- Do not connect strip or controller directly to AC power.
- Do not connect components other than those included to the power supply.
- Ensure the polarity of all connections is correct during installation.
Installation Process
Preinstall Check
Remove strip from reel and make connections to power supply and controller.
Controller will need to be paired to a smart device. Refer to controller user
manual for pairing instructions.
Briefly turn on strip using controller power button to ensure
proper operation of the strip, power supply, controller, and remote. After
successful test, disconnect power supply and disconnect components.
Layout
Layout strip on counter below cabinets. Hold strips up under cabinets or
measure to determine lengths of strip segments needed for installation. Cut
strip to desired lengths ensuring all cuts are made only on marked cut lines.
Strip Installation
Attach solderless connectors (STN8-2PC) to strip ends by placing the connector
fully over the strip and pushing down cap until it locks in place.
¹UL certification only applies to the included strip and power supply Next,
ensure all installation surfaces are clean and dry. Begin to remove strip’s
backing while adhering to bottom front edge of cabinets for optimal
illumination. Press firmly to secure strips to surface.
Route wire (WP22-2) for strip-to-strip connections under cabinet seams,
windows, and other spaces between cabinets. Cut wire to length and attach wire
ends to solderless connectors by placing the wire fully into the connector and
pushing the cap down until it locks in place. Ensure the wires are connected
to the correct polarity on the strip.
Controller and Power Connection
Use the double-sided foam adhesive pads (3M-FTP) to mount the controller.
Connect lead wires at the end of the strip run to the controller (MCSH2-1CH-
72W) with CPS Connector (CPS-F2ST).
Connect the power supply (CPS-24V-36W) to the CPS connector and apply power to check for proper operation .
General Installation Diagram
Note: Wiring may vary based on cabinet configuration and outlet availability.
¹UL certification only applies to the included strip and power supply
Rev Date: V0.2 04/21/2022 4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>