superbrightleds EL3-RW LED Emergency Light User Manual
- June 2, 2024
- superbrightleds
Table of Contents
superbrightleds EL3-RW LED Emergency Light
Specifications
- Model: EL3-RW
- Battery Type: Ni-Cd
Product Information
Warning: Check product label for specific electrical specifications related to installation. Improper installation will void warranty.
Important Safeguards
Battery in this unit may not be fully charged at the time electrical connection is made. Let the battery charge for at least 24 hours for normal operation. To check charge, press the test button.
Installation Instructions
- Carefully remove the mounting plate by using the release buttons.
- Remove appropriate knockouts for wiring and mounting from rear plate.
- Run wiring through mounting plate and connect wiring to junction box. (refer to wiring diagram)
- Securely attach mounting plate to surface or junction box with hardware.
- Connect battery to board.
- Reattach light assembly to mounting plate.
- Apply power and allow battery pack to charge for at least 24 hours before initial use/test.
- After the 24-hour period, press test button to make certain lights are functioning as intended.
Frequently Asked Questions
- Q: How long should I let the battery charge before initial use?
- A: It is recommended to let the battery charge for at least 24 hours before the initial use.
- Q: How can I manually test the lights?
- A: Press and hold the test button to illuminate the lights for manual testing purposes.
Warning
Read and follow all safety instructions. When using electrical equipment, basic safety precautions should always be followed including the following:
- Disconnect power before performing work on electrical equipment.
- For indoor use only.
- Do not let the power cords touch hot surfaces.
- Do not install in hazardous locations or near gas or electric heaters.
- The use of auxiliary equipment not recommended by manufacturer, may cause and will void the unit’s warranty.
- Do not use this equipment for other than its intended purpose.
- Servicing of this equipment should be performed by a qualified service technician
- All electrical connections should be made in accordance with National and Regional electrical code.
- Equipment should be mounted in locations and heights where it will not readily be subjected to tampering by unauthorized personnel.
- Allow battery to charge for 24 hours before first use.
- Unused wires must be capped.
Important Safeguards
Battery in this unit may not be fully charged at the time electrical connection is made. Let the battery charge for at least 24 hours for normal operation. To check charge, press the “test” button.
Specifications
Check product label for specific electrical specifications related to installation. Improper installation will void warranty
Wiring Diagram
Testing
Manual Test
Test button can be held to illuminate lights for manual testing purposes.
Installation Instructions
- Carefully remove the mounting plate by using the release buttons.
- Remove appropriate knockouts for wiring and mounting from rear plate.
- Run the wiring through the mounting plate and connect wiring to the junction box. (refer to wiring diagram)
- Securely attach the mounting plate to the surface or junction box with hardware.
- Connect battery to board.
- Reattach light assembly to mounting plate.
- Apply power and allow battery pack to charge for at least 24 hours before initial use/test.
- After a 24-hour period, press test button to make certain lights are functioning as intended.
Rev Date: V1 02/21/2023
4400 Earth City Expy, St. Louis, MO
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>