superbrightleds com DMX3-4CH-4A 4-Channel DMX512 Decoder User Manual
- June 3, 2024
- superbrightleds com
Table of Contents
DMX3-4CH-4A 4-Channel DMX512 Decoder
User Manual
DMX3-4CH-4A 4-Channel DMX512 Decoder
Important: Read all instructions prior to installation.
4-Channel DMX512 Decoder
Safety and Notes
- Product should be installed in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Ensure all mounts are securely attached and will support the weight of the decoder. Failure to properly secure it may result in damage or injury, for which the manufacturer does not assume responsibility.
- A DMX console is required for proper use of this decoder.
Specifications
Technical Specifications
Operating Temperature| -4°–140° F (-20°–60° C)
Supply Voltage| 12–24 VDC
Max. Output Current| up to 4 A per channel, up to 15 A total
PWM Output| 4 Channels
DMX512 standard| DMX512/1990
Connections and Controls
RJ45 input and output setting adjustment buttons
Button Function
SET button: Mode selection switch. Hold for about 2 seconds to cycle to the
next mode (A/H/S). + and – buttons: These increase or decrease the DMX address
value or select mode setting.
Operation
Each decoder will occupy 4 address codes. The first character on the display
will be A, H, or S to display the function setting.
The remaining three characters will be the DMX address (001–512) or the mode
selection.
When in mode ‘A’, the decoder is
being controlled by the DMX console. The digital display will show the first
DMX address with the next three consecutive numbers being the remaining
channels the decoder will use. So if the display shows ‘A001’, this means that
the first channel is 001 and the other three channels are 002, 003, and 004
respectively. When connecting to an additional decoder, the default value of
the next decoder’s first channel would be 005 and the others three channels of
it would be 006, 007, and 008 in this example.
When in mode ‘H’, the decoder is using the built-in test mode programs. The
remaining three character spots will display the below codes to indicate which
program is currently selected.
| Display | Mode | Display | Mode |
|---|---|---|---|
| 0 | Turn OFF output | -5 | Static Purple |
| -1 | Static Red | -6 | Static Cyan |
| -2 | Static Green | -7 | Static White |
| -3 | Static Blue | -8 | Seven Color Jump (Speed Adjustable) |
| -4 | Static Yellow | -9 | Seven Color Fade (Speed Adjustable |
When in mode “S”, press the SET button to enter the speed adjustment setting
for H-08 and H-09, then press the +/- buttons to adjust pattern speed.
Rev Date: V1 04/18/2022
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>