luminii KBL-F-V-SPI Kurba Pixel Large Vertical Flexible LED Strip Instruction Manual

luminii KBL-F-V-SPI Kurba Pixel Large Vertical Flexible LED Strip

Installation Instructions – Kurba Pixel

Once the location or pattern is determined for Kurba to be installed, start off by marking the area. Amount of brackets may vary dependant upon pattern. Reference diagrams below.

CAUTION : Reference diagram below on Can and Can-nots, when it comes to installing the Kurba Horizontal & Vertical!

Straight run with mounting channel

• Line up the spring clips to the mounting holes, followed by placing the mounting channel to the surface. Make sure its straight by using a level.
•  Secure channel to the surface by tightening all the provided screws. If mounting to something other than wood, we recommend using the proper hardware.

Curved run with mounting channel

• Determine the shape of the Kurba layout, then mark thel pattern onto the surface. Then, place a mounting bracket every 8”(minimum).
• The pattern may vary dependant upon the amount of curves.
•  Secure the mounting brackets to the surface by tightening the screw. If mounting to something other than wood, we recommend using the proper hardware.

Straight run with mounting channel

Please read all instructions prior to installation and keep for future reference!

1.  PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
2.  USE ONLY WITH CLASS 2 POWER UNIT
3.  24 VOLTS DC
4.  SUITABLE FOR WET LOCATIONS
5.  SURFACE MOUNT ONLY

WIRING DIAGRAM

SR-DMX-SPI
Smart Pixel LineLED Decoder

NOTE :

• Please make sure that power is turned off before wiring. Also, ensure that the correct power supply (voltage and wattage) is used to power the LED strips connected to the decoder. Follow illustrated wiring diagram. Use a screwdriver to open and close connection slots.
• When connecting two or more LED strip lights or light fixtures, always make sure the signal direction arrows are pointing to same direction The signal direction arrow should appear on each section (cut increment) of LED strip

CONTROLLER WIRES

OPERATING GUIDE

There are three buttons on the decoder.

• Parameter Setting
• Increase Value
• Decrease Value

After operation, if no action was taken within 30s, the button lock, and backlight of the screen will turn off.

•  Long press M button for 5s to unlock the buttons, and the backlight will turn on.
•  Long press M button for 5s to switch between test mode and decode mode after unlocked.
• During test mode, the first line of LCD will show: TEST MODE. Use test mode to verify RGBW Pixel functionality.
• Duirng decoder mode, the first line of LCD shows: DECODER MODE. Use decoder mode when connecting to a
• Controller and for final installation and customization.
• The second line of the LCD Display shows the current setting and value. Note: 1 Pixel = 1 Cut Increment

MODE TABLE

PROGRAM TABLE

Documents / Resources

| luminii KBL-F-V-SPI Kurba Pixel Large Vertical Flexible LED Strip [pdf] Instruction Manual
KBL-F-V-SPI, KBM-F-H-SPI, KBL-SF-V-PL-SPI, KBM-D-H-SPI, Kurba Pixel Large Vertical Flexible LED Strip, KBL-F-V-SPI Kurba Pixel Large Vertical Flexible LED Strip
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>