OtterBox 77-89452 2 in 1 Power Bank MagSafe Installation Guide

Installation Guide

SETUP

1. Fully charge Power Bank with the included cable before first use.
2. While charging, the display continually shows battery capacity as follows:
   • 1 flashing LED| < 25% capacity
   ---|---
   • 1 solid LED, 1 flashing LED| 25-50% capacity
   • 2 solid LEDs, 1 flashing LED| 50-75% capacity
   • 3 solid LEDs, 1 flashing LED| 75-99% capacity
   • 4 solid LEDs| 100% capacity
3. When not charging, press the button to view capacity:
   • No LEDs| 0% capacity
   ---|---
   • 1 flashing LED| 0-10% capacity
   • 1 solid LED| 10-25% capacity
   • 2 solid LEDs| 25-50% capacity
   • 3 solid LEDs| 50-75% capacity
   • 4 solid LEDs| 75-100% capacity

WIRELESS CHARGING

1. Press the button on the side to turn on Power Bank.

2. Charge indicator appears in the phone or watch screen.

3. Power Bank auto-stops charging when the phone or watch is full or if the battery level becomes too low.

4. To manually stop charging, press and hold the button.
   Note: Wireless output is automatically enabled when connected to a power source.

DUAL DIRECTION CABLE CHARGING

To charge a device with Power Bank via a USB-C cable:

Plug the cable into Power Bank and then into the device. Charging starts automatically.
If it does not, press the button to initiate charge.
Recharge Power Bank with a USB-C cable and charger.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>