OTTERBOX 78-80534 Wireless Power Bank for Magsafe Instructions
- October 27, 2023
- OtterBox
Table of Contents
78-80534 Wireless Power Bank for Magsafe
Instructions
Wireless Power Bank for Mag safe
USE INSTRUCTIONS
More product information otterbox.com/support
otterbox.com/accessories/mag-safe
2056698 A
WIRELESS RE-CHARGING
(Power Bank only) Place Power Bank on Qi or Mag-Safe wireless charger.
(Power Bank and iPhone together) Place Power
Bank attached to iPhone on Qi or Mag-Safe wireless charger — iPhone powers up
first, then Power Bank.
WIRELESS CHARGING ERROR
If all 4 LEDs are flashing remove any metal objects from the vicinity of
charger.
DUAL-DIRECTION CABLE CHARGING
Charge a device with Power Bank via a USB-C cable.
Recharge Power Bank with USB-C cable and a charger.
REMOVE POWER BANK
Remove Power Bank from phone with one hand using a twist motion from the
bottom.
This device complies with Part 15 of the KC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference.
and (2) this device must accept any interference received. including
interference that may cause undesired operation
SETUP
Fully charge Power Bank before first use with included cable. While charging display continually shows:
- 1 flashing LED — < 25% capacity
- 1 solid LED, 1 flashing LED — 25-50% capacity
- 2 solid LEDs, 1 flashing LED — 50-75% capacity
- 3 solid LEDs, 1 flashing LED — 75-99% capacity
- 4 solid LEDs — 100% capacity
When not charging, press button to view capacity:
- No LEDs — 0% capacity
- 1 flashing LED — 0-10% capacity
- 1 solid LED — 10-25% capacity
- 2 solid LEDs — 25-50% capacity
- 3 solid LEDs — 50-75% capacity
- 4 solid LEDs — 75-100% capacity
WIRELESS CHARGING
1 Attach Power Bank to Mag Safe- compatible iPhones and cases
2 Press button at bottom to turn on Power
Bank
3 Charge indicator appears in upper right
corner of iPhone (standard function), and first Power Bank LED displays green
during charging
4 Power Bank auto-stops charging when phone
is full
5 To manually stop charging, press and hold button
Industry Canada Statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Statement
The product comply with the IC RF Exposure for Low Power Consumer Wireless
Power Transfer. RF exposure limit set forth for an uncontrolled environment
and are safe for intended operation as described in this manual. The further
RF exposure that compliance was demonstrated at 20cm and greater separation
from the user body or set the device to lower output power if such function is
available.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
–If device include 15B
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from thatto
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement
The product comply with the FCC/IC RF Exposure for Low Power Consumer Wireless
Power Transfer. RF exposure limit set forth for an uncontrolled environment
and are safe for intended operation as described in this manual. The further
RF exposure that compliance was demonstrated at 20cm and greater separation
from the user body or set the device to lower output power if such function is
available.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>